The Jalopy Journal
I'd fix it.I don't worry about the time it takes.I enjoy the challenge.
Sure is alot nicer than my 41 when I got it.Good save.
Nice selection of cars.Some wild paint going on there.Thanks for sharing.
We've been married for over 50 years.Neither of our reg. cars have been in the garage.The ply. was built and was in the garage.Before I retired I...
350 olds in my 41 ply.Been in there for 35 years and still runs great.
Awesome!
When are you sending out tags again.I fixed my address as you suggested
Looks good from either side.
Yes,We all do.
350 olds in my 41 ply.Hasn't missed a beat in over 30 yrs.
I think all of us will be better when Spring gets here.
Great hot rod and story.Welcome to the HAMB.
I'm building a 56 F100 and going for the mild custom route.I'm using a 63 chrys. quad headlights with a 6 bar stainless grill.And 51 merc tailights.
My 41 ply here.I used mid 70's chrysler rings and fit them in the fenders.sinks the lights in about 1 1/2 inches.
Great video!!
Good looking Buick.I like it.
Thanks for the replies.Everything seems to line up without them but when I get some miles on it I'll see if there's a problem and need them.
title should have said from firewall TO front of inner fenders.I've seen some guys use these on the 53-56 f 100's and some don't.They attach to...
That's a good suggestion.Didn't think of that.Thanks
Thanks for all the replys.I think it might be to short.
All right,with the frame supported and the weight off the rear.The drive shaft goes into the tail of the trans.The measurement is now 1 1/4".Not...
I have the jack under the rear.I'll try it hanging free and see whats left in the trans.
I have a 56 f 100 with a C4 trans and 8 inch rear.Right now the yoke is 2 1/8th inches inside of the tail shaft of the trans.That's about half of...
Merry Christmas Everyone!
Looks great.
Thanks for the replies.
The bed sides of my pickup bed were painted with 2 K primer 8 months ago.If I sand them with 180 sandpaper can I paint them with Blk. urethane or...
Sorry for waisting your time.There are only two drain plugs.One on the back of the driver side and one on the front of the passenger side.These...
Thats beginning to look like the solution.Thanks for all your help but I sure would like to know what the answer is.This is my first Ford engine...
I tried 1/4" npt and they were to big.1/8" to small.Is it possible that they are Metric?
Separate names with a comma.
The Jalopy Journal
