The Jalopy Journal
I was at the hardware store and looked at the pvc board and was just wondering
Just throwing this out there. Is there any reason someone couldn’t replace the wooden toe board with 3/4 “ pvc sheet stock? It sure as hell won’t rot
For now a rebuilt '40 3-speed
I'm actually looking at a 168 tooth Ram billet flywheel model # 1530. Its drilled already for b/b, long and diaphragm
Thank you!
Yep, just hate to wait till Monday, thanks
I recently purchased a 383 sbc for my ‘40. This new motor has a one piece rear main seal so I have to purchase a new balanced flywheel. I found...
Thank you very much!
Part # by chance?
HOTRODA did you have to drill and tap?
Thanks for the pic, yes, please send me the part number, thanks!
Thanks for your reply, the place I’m getting the flywheel from isn’t sure my pressure plate will bolt up, but I can always have it drilled, tapped...
Thank you, I’ll check those out
Hello, I hope someone can give me the answers I so desperately need. Heres what I got. 1940 Ford with a worn-out 350. It has the adapter to the...
Hello, I need some advice, please! I recently purchased Steele Gaskets and Im wondering which side goes to the outside, thin or fat side of the...
Thanks for the info Brent. Are you referring to the '28/'29 A aprons or AA
I thought the same, but the previous owner used the apron to clean off his boots, pretty dented up
Hopefully someone has the answer for this one. I'm running a fenderless '31 coupe, but want to run the splash aprons. The stock aprons are a...
Thank you!!
Are these left/right or can they be used either side
What did you do to lower both the front and rear
Separate names with a comma.
The Jalopy Journal