The Jalopy Journal
Yes vent tube is clear.
It seems like extremely odd to me that it does not leak while running/ driving no matter how hard im leaning on it. Almost like there is a relief...
I have since eliminated the radiator cooler and gone to a external cooler. 100% sure its coming from input seal used a scope camera and verified...
Thank you, it leaks immediately after shutting off for a few seconds then stops. The trans fluid looks milky, so I will be doing a flush on it...
Have a th350 that has all new seals. The converter/ input seal leaks but only when I turn the engine off. Wont sweat a drop otherwise.. Anyone...
Haha, I do appreciate the feedback as always. Just trying to lighten the mood.
And yes my feeling is hurt
Well thanks for all the over sensitive replies, musta been nice being born everything. An open carrier rear end applies torque to the wheel with...
I have a 9” ford rear in my 55 with a full spool. The car is strictly street driven and am tired of the spool on the street. Can I slide out say...
Just put a “gone through” muncie m20 in to a 68 camaro with a new muncie shifter, rods, clutch. Its is popping out of 2nd gear when coasting and...
Awesome relies thanks guys. I using the under floor pedals
Ive gone the hydraulic route before, would like to stay with original pedal and a linkage set up. Its all real close, would like to see what...
Anyone put a sbc in to there buick with a standard clutch? Needing some clutch linkage ideas. Thinking of cutting the pivot ball end off my z...
Those are nice pieces indeed. Pricey, especially for me to get them to Canada but a good alternative to build if I need shorter arms.
With trailing arm axle pads in stock c10 location they clear spring mounts. So im hoping angling them in a little more will get me inside the x...
Your 40 must be quite different as my upper coil spring mounts are centered over axle
Thank you! I know jalopy kid moved the arms in 2” on each side on axle. To get them inside the x. Did you mount in stock location on axle and...
Lots of good info on here I have read through already and got a pretty solid plan in place I believe. Ive got a 55 buick special 2 door post I...
Awesome, thank you! I ended up mounting engine last night with mount reversed like yours and only drilled frame bracket big enough for bolt to do...
Instructions also show washers that arent included (between bolt head and lower rubber and between upper nut and engine mount). Anytime you add or...
Yah I read those, says tighten until is “starts” smashing the rubber. Haha.
Thank you
Is it intended to flatten out? I think I read 20ftlbs somewhere
$300 for an engine mount by the time it gets to my door here in canada sure doesnt seem like walmart pricing! Wish I had an endless supply of...
A 55 buick special gasser Im building
Thanks! Pictures would be greatly appreciated
The nut has to go on top. Because of the stepped/ shouldered bolt it can only go that way. Thats the way it was designed
Im sure whatever way I decide to run this it will be fine and Im just over thinking it. I think Im gonna go with the approach of using the bolt...
Hahaha
Being in Canada getting these parts is expensive and takes forever so Id like to use what I have. This is what id end up with. Its only a 300hp...
Separate names with a comma.
The Jalopy Journal
