The Jalopy Journal
LOL
The rubber is so old that it melted and then hardened again. It was hard to get the trim off the inside. But the metal body edge was pretty much...
Thanks for the quick replies! is it correct to install the glass in the rubber, then apply the 3M in the channel against the window---and then...
I am getting ready to replace the windshield(s) on a 1939 Nash. Their tech manual says to insert the rubber, insert the glass, and then use glue...
Thanks! Everything helps
I couldn't find Vintage Ford Spec. Any ideas? I am sure that I will need the outside ring and other little parts once I get it off, Thanks
I found the Hartz Cloth. Convertible top cloth with a cotton backing---perfect!
It could be RV coating. It's tough. I am going to tape off the area where the overlap sealer is on the painted roof, so if I have to repaint, it...
That's what this looks like---must be original. I will look up Vintage Ford. Thanks
You lost me with the screw inserts. It sounds like a good plan, but I wouldn't know where to start. I have to look up Hartz cloth---is it...
I have a '36 Ford Sedan that has a "vinyl" roof insert that looks different from the new ones advertised. It is almost at the same level as the...
[ATTACH] I think this would look good with a wide 5 in the middle, sticking out :)
Why would it howl? I plan on using Winters helical cut gears. It is a 10 spline with 31 spline axles. I haven't opened it yet to see if it has...
I thought if this was used in a Late Model, it would be fine on the street? I don't know anything about these rears. I see a lot of posts with...
LOL, I am thinking about it. The rear is easy, just a different look. I have never seen one on the street. The front setup is gonna be harder....
I picked this up today (well, two of us picked it up). I never had a QC before and only saw them under race cars. I built a drag car out of a...
Separate names with a comma.
The Jalopy Journal