The Jalopy Journal
I wanted to avoid the problem that you described along with the resultant oil leaks, so I used "Thompson" shafting. It measures (i think) within a...
I also had a bad experience with Williamson's. I cannot recommend them. Tom
Hey, you guys need to get with it.;) I have been using this device for decades, "Ankorite" gasket cutter. It will cleanly cut circular gaskets...
Deke, thanks, that's a big help. Tom
Your workmanship and methods are first class. I will need to reverse the arc on the front spring on my '34, will a two ton arbor press be adequate...
Looks like you are doing a very nice install! I think you are going to need a sway bar, a '40 sway bar bolts right in after slight modification to...
I purchased a Malpassi fuel pressure regulator awhile back from a company in Europe and it was delivered in less than a week. I could hardly...
Stand your ground, GOOD on you. Tom
If you really want to lace the wiring harness in accordance with government standards, several publications are available including SAE AS50881 -...
Very nice work as always, looks like a factory installation! Tom
Purchased a pair last night (Sun.), there were only six pair left. Tom
I read thru this thread earlier this morning for the first time, got to the end and my heart sank. What a blow this must be to the family. R.I.P.
You're going to love that Columbia rear axle, nice lookin' shop! Tom
I just received an email from Steve Coonan at Rodders Journal, "issue #87 is in the mail." Tom
Read all of these. I have a t coupe and want to remove rust from sheet metal, then prime immediately, any good ideas Thanks in advance. I would...
Good explanation, Rick! Tom
I believe that the process "chelation" is very effective. I just had a problem trying to convince some people on this board that the COMBINATION...
Very cool Hank, ain't technology great! Tom
Hank, I've been following your project and that lazer equipment looks like it does a terrific job. Tom
Bandit Billy, where did you source the structure? Thanx, Tom
The "bolt" is actually a plug that caps a pressure relief valve, the "shaft" is actually the main oil gallery. It doesn't come out. Tom
What is this NASCAR thing you speak of ? Tom
Fusbc, I sent you a P.M. Tom
Just keeps gettin' betta'! Tom
Several years ago I installed a "Malpassi" brand regulator, the adjustment is very sensitive, several models are available. I would never use...
Well done! I can't imagine the amount of time that you have invested in this work. Tom
Contact Boling Bros. they will have the correct backing plates to use on a '32 rear axle. Tom
I had the same problem, in addition to the problems you described, you will find that the wheel cylinders when installed will NOT be level and it...
Kelly, I have started a conversation with you. Tom
BAA-LING! HAHAHA!
Separate names with a comma.
The Jalopy Journal
