The Jalopy Journal
I have a 48 Ford Conv. with C-4 trans. Who makes a good cruise control that is simple to install? Thanks
I found a Cole Hersee 24115 at O'Reilly $65.38.
I am looking for a two wire starter button. Something that will fit existing hole. Thanks
I have a 48 Ford Conv. Stock engine with C-4 auto. Looking for a good cruise control. Thanks
I have a 48 Ford Conv. and right side mirror is useless. You can't see it from drivers seat. Has anyone mounted the mirrors on the doors? Thanks
I am looking for someone who makes custom speedometer cables. Have 48 Ford engine with C4 auto trans. Thanks
I am looking for a good cleaner for my black tires. Don't want anything shiny .
I have a C-4 Ford in my 48 ford and need the 2 seals for speedometer. Where can I get one around Portland, me
Thanks I think I found somer, Steve
Could not get hold of them. Any other dealers ? Thanks
I am looking for some lug nuts for my 48 ford. I am looking for the ones that the threads start a little ways in the nut not the ones that threads...
Thanks I will stick with the 3.56
Forgot to mention I have a C-4 auto trans,
I need to change the rear end gears in my 48 Ford. It has been bored and stroked to 265 CID. Stock cam, electronic ignition, stock carb. electric...
Thanks, how can I check that out, can it be repair or better to buy new shaft.
First I had one from S......Y that was foreign made so returned and got American made kit from HotRodWorks. The yoke is loose on the pinon shaft.
I HAVE A 48 FORD THAT COVERED TO OPEN DRIVESHAFT Have replaced seal twice in about 1,000 miles. Dropped driveshaft today. with the pin and set...
I now have dual smithy's on my car now but are getting too loud, been on car for 12 years. I would like something quieter but with good sound,...
Thanks very much, sounds like a good idea to bend rear seal.
Thanks, can you use the right stuff with oil pan gasket, or use it without pan gasket ?
The cork gasket is leaking on the rear of 48 Ford oil pan. Engine is in car. Whats best cement to use that will hold cork gasket in block until I...
Talked to Speedway Motors today. The Yoke was drilled wrong, they are sending me the correct one. Thanks for everyone's help.
could I do this with rear end in car
Is it possible to remove pinion shaft without taking the rear end all apart. The reason I ask as I change to open drive kit from Speedway and...
Thats a good idea to use two gaskets, Thanks Steve
WHAT ARE THE BEST GASKETS TO GET FOR 48 FORD V-8 COPPER OR THE OTHER TYP[E, THANKS
I have there kit but directions are not helpful. Will call
Got ready to instal my C-4 auto into 48 Ford with engine in car. Can't seem to have room to install trans. I guess I will have to pull motor to...
Separate names with a comma.
The Jalopy Journal
