The Jalopy Journal
I have helped many with this same problem and had great results with laying the panel up on the steel top bench and first coin the ends with a...
28dryer contact me at 507-263-7411 Dan
Paul contact me at Route56wingnut@yahoo.com. Dan
There is no reason to even think of a 90 ton off shore overpriced unit when you can get an American made one for around 6500. That will lose only...
I have to ask if you have ever used one for any project ? They are not designed to replace a plasma or H press but to complement them . No tool is...
I have to go to south Florida and will be able to haul on an open trailer anything you need between here and there . Don't know how much room on...
Why would you advise someone to shrink an area that is obvious by the picture to not have enough metal already is beyond my thinking . Here is a...
First off your cut patern is not correct and is not giving you enough sheet metal for your radius . Second issue is that you need to shape the...
I have been trying to make contact with Ben and I get no response . Does anyone know or have been in contact with him .Please PM with any info .
That is a Yoder 90 on one side and a P-2 pettingell on the other . The yoder is a 120lb hammer and the P-2 is a 90lb one . Cant wait to see...
[IMG] [IMG] [IMG] [IMG] [IMG]Don't forget your ear plugs for the Spring Event in Dennison[IMG]
[IMG] [IMG] [IMG] [IMG] [IMG] [IMG]Getting closer with more paint and motor plate finished for the Petingell . Hard to work on your own stuff...
Bttt
I am getting ready for my spring Route 56 Metalshaping Event in Dennison Mn. For those of you on the Metal sites you already know how this fills...
Got the upper on to see if I measured correctly.
I still have to put the stabilizer brackets on and the electrical. I still have a #1 Pettingell but think that is best used as trading material as...
Got my YODER-GELL Power hammer further along this week .I built the tower from 3/4" plate and had it bent for the radius corners at Empire Bucket...
I think we need to have Phil Robertson check in on this and give his opinion .
Gregs just old and too lazy to bend over and set the choke :D . I just dont get putting a band-aid in place of a perfectly good working unit .
That carb is about as dirt simple as it gets . I dont know why you would change anything but a new choke spring and let it go .Seems a big waste...
bttt
That band saw frame does not have enough backbone for a power hammer . You could take that Ewheel you have and convert it to the saw frame and you...
What he is referring to as a hole punch is actually a gasket or leather punch that you can buy at the china tool shop at the swap meets. An easy...
For those that are not involved with the metal sites out there , We are having our Fall event on Oct 17-19 . Please let me know if you are...
Unbolt the final drive assy. from the trans along with the brackets that support it and the axle support to the engine . Then all you have to do...
The concern of a car falling backwards off of a 2 post lift because of improper placement of the arms by a sloppy operater would be just like...
I would say that in my opinion anyone that is touting the advantages of a drive on rack is a hobyist and not doing multi functions on a daily...
bttt for sunday viewing
Separate names with a comma.
The Jalopy Journal
