The Jalopy Journal
That was my impression. Hub, and adapter all in one. I made up a 1/4" spacer that slipped over the shaft. Then put it all back together, and now...
Okay. Thanks
I fixed it. I got a spacer, and cut it in half. Now it gives me about 1/8th of a inch clearance. Now though I have a tilt column. From side to...
[ATTACH] [ATTACH] [ATTACH] I have two washers on it now over the spring. I just took the wheel off and took a couple of pictures of it,
That hub is attached to the wheel. Fits good on the spline, When I bought it a number of years ago I remember it was a direct fit to a GM...
I will try 1/16" at a time.
Okay. Hope this helps.[ATTACH] [ATTACH] [ATTACH]
The whole adapter is aluminum. It hits at the edge of the adapter, and that column housing.
Yes. I have a aluminum one. It goes over the steering shaft. When it is tightened down the outside edge of the adapter hits the top of the column...
I bought a aftermarket GM steering column. A hub adapter came with a Grant steering wheel. After installing the hub adapter, and when I tighten...
I will go next week, and see if I can get the casting numbers off of one of them.
That is a picture of the rear end back from when I bought the car.
[ATTACH]
I pay for the materials. Not the labor. Are there numbers stamped on the wheel cylinders?
I got that from my pictures. It is also 5 on 4 1/2" bolt pattern. The front is from a Mustang II that had 4 lugs. I converted to 5 with the 5 on 4...
For that I will have to wait til I get the car back.
Hi. I have a Ford 8" rear end. I have had this car for 17 years now. I was told back when I bought the project that it was a 9". turns out it is a...
What size front rotors can you use with 15" wheels.
I am going to install it as one piece. There will be floor mats. Nobody will be sitting in the back seat. Will only be driving it a few times a week.
I always have to wear shoes. Diabetic. Have to be real careful with my feet.
The carpet I am looking at right now is also poster on that site you sent. A Super Flex Ozite. I am checking to see if I can get a sample.
Can that Stainmaster carpet be molded over the hump?? I built my floors, and there is a hump over the transmission. I don't want a bunch of...
It looks real nice, but are afraid of catching the loops?? Or are there any loops in this carpet??
That surface looks like the material I am looking at. I think it is like a cut pile. I guess it is kind of thin, but it flexes easy. I don't need...
Been doing some looking at Auto Trim Stores. A suggestion is for a cut pile carpet. To mold the carpet over the hump. Use steam, and spray on...
Hi. My 37 Ford Tudor is being finished, and will be painted soon. When I get it back I will be putting the door panels back on, and putting a heat...
At first after taking a loop out of the coil springs. It dropped maybe 2". I then put on 2" drop spindles. I couldn't put a pop can from the...
I have a 37 Ford Tudor. Had it for many years. I bought wheels and tires for it maybe 20 years ago. The tires are in great shape, but have to be...
Thank You all again. When it is all done. I will post pictures. I think the main reason it has taken so long is that where I worked. We only got...
Separate names with a comma.
The Jalopy Journal
