The Jalopy Journal
Its entirely possible, given the one piece axles that its a Dana 41 out of an old jeep. Hard to say for sure but its definitely a Dana 41 center...
Interesting. Looks like those are one piece axles. Hmmmm
[ATTACH] Here you can see the bolt on hub.
These rear ends, in Jaguars, came with a bolt on hub at the wheel. These were commonly found in Jaguar XK's.
Try this thread, might just have the info youre looking for...
Car manufacturers share capacity all the time. Not uncommon for Dana/Spicer to build things for other companies and fit whatever tubes/axle ends...
Looks like That's out of an old Jaguar and looks like it has 4.27 gears. 4HA model designation more specifically. Very similar to an old Dana 44...
Yep. Go down to the DMV or registration service shack and apply for a lost title. If the car is NOT already in your name, good luck.
I would guess you got the trans hot and it pushed the fluid out the vent on top of the case.
Are you buying them from someone in San Diego and need someone in San Diego to hang onto them for a week before they head up to Oregon?
I really like it. Is it cast aluminum?
A big brass hammer or a big hammer and a block of wood so you dont ding the spring up and smack it back into place. It helps if you loosten the u...
That rear end uses a crush sleeve to set the pinion bearing preload. Replacing the seal without putting a new crush sleeve in and thus, setting...
is your idle speed set above 1000rpm? If so its rinning off the venturis and not the idle circuit. May also be a vacuum leak as well.
I had something similar with a scout I built. It turned out to be a bad master cylinder that was sucking air past the seal where the pushrod goes...
Shoot me a pm if you want a hand. I live in Santee and would be willing to take a look and help out. I have a garage full of tools and a welder...
I bought one a few years ago and it took them 3 trys to get me a carb that worked right.
I really dig the color of the wheels you have it mocked up with. What do they call it? Looks kind of like coffee with creamer in it.
Not trying to be a smart ass by any means but, my supplier(airgas) sells 86%co2/14%argon as their steel mix. Mixes can vary substantially by...
If you like country try 97.3, 92.1 or 95.7, classic rock 101.5 or 102.1, hard rock 105.3, jazz 98.1, hip hop 90.3 or 93.3, alternative/classic...
Check your firewall connection. I have a 63 impala that had wipers one minute and none the next for a loooooong time. I happened to be cleaning up...
straight argon is for aluminum. Go trade your bottle back to the guy you got it from for a steel mix (mixes vary by supplier) or straight co2. You...
Cool, good luck.
Figured if I was local I would lend a hand. I am in san diego. How do the battery cables look? Had a similar problen on my impala and turned out...
Smack the starter a couple times with a hammer while someone turns the key. Does the engine spin over by hand? Where in so cal are you?
Yeah, I know where to get new stock replacement parts but it will always be a leaky pita so I would like to not replace them for the third time.:)...
Did you use an off the shelf center link to convert your 62? If so do you remember what it came off of?
Thanks guys! The speedway kit looks like exactly what I am trying to do. The price isnt bad either. Thanks!
Alright, I have a 63 Impala I have had for 20 years. It has the ram assisted power steering that has always leaked and been a pita to find parts...
Nearest rear end with that bolt pattern on the cover is what a previous post here said....Chrysler 8.25 but to my knowlege they did not use a...
Separate names with a comma.