The Jalopy Journal
Just finished this 1950.. [ATTACH]
Lol..it feels good to be Hoodlum!! It's a 454, tremec 5 speed, and 12 bolt post out of 69 camaro. It's a total no frills hotrod that's an...
I bought a GoPro camera off my buddy and decided to give it a try yesterday morning. I grabbed a couple clips grabbing a few gears and did my...
Yup..I was there and it was packed as usual. It's always a good time with a nice variety of cars.[ATTACH]
I had one for close to 20 years and recently stepped up to a Miller 211. The sidekick is perfect for bodywork, sheet metal and mild fab work. My...
55 210, 468, Tremec 5spd, 3:73 12 bolt posi.
I wear nothing but these in the garage. Affordable and very comfortable. http://www.amazon.com/HMS-80s-Fishnet-Shirt-Black/dp/B002MVVLAI
Looks good for a car that's not a 31 Model A on 32 ford rails....just say'n. Thanks
My work in progress.... [ATTACH] [ATTACH]
[IMG]
The 48 I built.... [IMG]
Dropped the big block in..... [IMG]
I'm moving the battery to the trunk and filled some of the holes in the firewall. I shot the firewall single stage gloss black. [IMG] I did the...
A little more progress ... Blasted the frame and firewall [IMG] Painted the frame with por15 and getting ready to clean up the firewall and lay...
The motor is cleaned up, painted, and ready to go back in once I paint the firewall and front frame components. [IMG]
A couple updates... I fitted a 1969 Camaro 3:73 12 bolt posi. I set the pinion angle and welded on new perches.... [IMG] [IMG] [IMG]
Work in progress....[ATTACH]
Where did you find all the Chip n' Dale dancers to help put the body back on? ;)
I ended up putting disks on the front. It stops pretty good (not that I drove it that much before I pulled the motor). I scored a 12 bolt posi...
I checked the run out on my Lakewood scattershield and bolted up the tko 600 for a trial fit. I needed to cut the tunnel a little but it seemed...
Thanks for the picture...that helps!
I have a lakewood scattershield (the one with the provision for the bellcrank bracket on the side). Do I use the 55 clutch fork and pivot ball...
I gave up on the Sanderson headers and bought a set of Earl Williams headers and mounts. No more stearing issues and everything seems to fit...
You could run disks with a non power master cylinder. I had that setup in my 34 and my 48.
Yeah..it's 3/4" forward. I gave the specs to Sanderson before I bought them. I sent them some pictures but have not heard back yet. Hopefully...
Turning left is probably over rated.....
Sanderson Headers are in snug and it looks like I have clearance issue with the drivers side tierod hitting one of the tubes. Thoughts? I sent...
We dropped the big block in place today. The motor mounts move the engine forward 3/4 of an inch and gives it just enough room to clear the hei...
A couple updates, I pulled the 302 (cam went flat) and acquired a 454 to take it's place. I also scored a 12 bolt posi out of 69 camaro for...
Hey gang, My small block self destructed and I picked up a 454 (72-78 2 bolt) with 781 heads. The previous owner had it in truck and rebuilt...
Separate names with a comma.
The Jalopy Journal
