The Jalopy Journal
Gone.
Factory Buick 215 v8 four barrel intake decent shape $75.00[ATTACH]
Isky pushrods for a Buick 300 1964 aluminum intake the length is 8.625 never used $75.00 + shipping[ATTACH][ATTACH]
Isky racing valve spring retainers. Part# 627-ST. $ 50.00 + shipping[ATTACH]
Iskenderian racing cams valve springs never used from a old project I was doing, part # 625-626 Buick v8 or v6 install height 1.687
Sold!
(Bttt)
$125.00 obo + shipping
Used edelbrock carb part #1406 complete no missing parts $150.00 + shipping
Buick 300 1964, Iskenderian duel valve springs, spring retainers, shims, and push rods never installed $175.00 + shipping
1962 Buick Special project 65 Buick 300 motor with th350 trans runs and drives new breaks suspension parts needs some tinkering to fine tune it...
Chris, I'm not really sure on the exact measurements I know that its right under the heater core and then I cut the width to the transmission and...
I ended up useing a 65 Buick 300 bolted right up to the v6 motor mounts and used a th350 trans I cut the floor about to the tail shaft and up to...
I really like the bell flower exhaust tips where did you find them? Bob
I'll have to head to the junk yard.
I'm looking to up grade my steering column, in my 62 buick special, I recently put a 3 speed trans in, and a steering rack, and the old column is...
Great pictures, Beautiful country.
I'm thinking on cutting the tunnel and raising it up and putting a one piece shaft in, I didn't want to change out the rear end if possible
I'm swaping out my 198 v6 and 2 speed trans with a 65 buick 300 v8 and a th-350 trans in my 62 buick special, and i'm not sure what to do with the...
I see you put new carpet in,where did you get the carpet from, I need a carpet kit for mine I made one to just get by and it shows too. Great job...
Great job, what kind of wood did you use?
I have a 1962 Buick special that the front end needs an overhaul, maybe someone can give me some advise, with the cost of a rebuilt I could...
I figured out a way to cut a sealed beam headlight, I took a 1/16" tile saw and made a arbor to fit and to chuck in the drill press, I used a used...
I'm making 2, hi beam 5 3/4 headlights, with replaceable halogen elements to look like old blank guide seal beam lights and 2 more with H.I.D for...
I'm trying to cut 5 3/4 round sealed beam headlight where the seam is to make a headlight mod. Can it be done or am I just wasting my time
I have a 1962 Buick special with a original v6 drive train, should I just leave it or I was thinking a small v8 like a 300 any suggestions
Welcome from Antigo
I have the same car 62 special v6 auto with 13 in wheels all stock I got it about three years ago I plan to make it a simple custom. I converted...
I'm trying to fit a five speed transmission to my 65 buick 300. Will a 1995 t-5 manual transmission work, or do I need an earlier T-5 tranny....
I'm building a 65 buick 300 with a t-5 , 5-speed manual trans, and my question is, what flywheel should I use, what years and what parts are...
Separate names with a comma.