The Jalopy Journal
Hey fellas I have a question about a boared and stroked flathead. It has a 4" merc crank and bored .060. When we pulled the heads off there were...
If you don't like the question don't answer! How hard is that. Not like his question is taking up room in your life, get over it and read on.
[attach] [attach] [attach] [attach]
Keep it.
bump
I would check the new wires also, I have had a bad experiance with new wires and one of them was bad. It would idle ok but as soon as I would get...
I am putting a new rear end in my 54 Buick. I have coil springs and the pan hard bar mocked up. I want to see what some of you have done for...
Clean one owner never been raced. Looks fun man post progress pics.
Brand new timming gears and chain timming and dwell is set points fairly new and condenser I am not sure about.
1963 Chevrolet C10. It has a 283ci and a four speed on the floor. I am not sure the trans name.
So this morning I was driving noth on I15 from my house to a school about 30 miles away. Everything was going great truck was running great, motor...
I thought I saw it the other night thanks man.
I want to change my signature and I am unable to find a way. Anyone know how or even if it is possible? HELP
It was running and driving. I bought it from a young kid who drove it from mississippi to salt lake. When I bought it it was running ok but it...
Ok so i found the mark on the crank gear it is straight up, and I think I found the mark on the cam gear it is off the nylon and on the metal...
I think I found the mark on the cam sproket it looks like its pointing about 12 o-clock at TDC but I am still unable to locate any mark on the...
It does backfire through the carb when I hit the gas. I have checked my timing, compression, valve springs and pushrods. It ran fine before I...
I think I may do that.
I have a SBC 283 and I am troubleshooting a backfire problem, anyhow. I pulled the timing cover off to check the alignment of my timing marks on...
I will have to get the numbers and post to see if we can find out. Page 48 on the Kanter catalog also shows a 241ci as a V8 in 55-57 also.
My cousin just bought a 1951 Desoto with a straight six. The guy told him its a 251ci. The parts mag we have been looking at from Kanter auto...
I want to convert my generator to an alternator. I have read a couple different ways of doing so but I want to know what is the best way to go....
I have a 54 Buick and low band went out. I have taken the trans out and apart to find my front pump has worn a groove in the backing plate. Anyone...
Separate names with a comma.
The Jalopy Journal