The Jalopy Journal
Check breaker #12 on the main panel in the house. Happened to me one time.
Is there not a sleeve that goes behind the bearing that comes in the kit to convert to Granada rotors on a stock M2 spindle. This is for using a...
This gave me a lot of grief, mine was mopar but chev may be different.
Sometimes those thick copper seals shown in your picture of the rear caliper restrict flow to the caliper. There is a groove that has to line up...
Remove the wheel cyl pistons & rubbers and drain the line completely. Heat the cylinder & fitting with a torch, if its still seized then try and...
Yup, an act of god. Get some chrome insurance and maybe some earthquake and flood insurance as well.
Is this legal??
Straight Co2 requires more heat and is not as consistant as Argon mix. Also produces a raised bead which sometimes has to be ground down. Other...
Anybody watching game 3?
Doc changed my meds, I'll tell him they're working.:eek:
The devil went down to Georgia, he was looking for a s10 frame to steal. He was in a bind 'cos the build was way behind: he was willin' to make a...
Hell, I put an S-10 frame under my S-15 and now it handles like an S-10. The mounts were even the same. Go figure.
Chevy truck mounts are easy to fab up.
This is just me, but I would dry sand it back with 220/320 to your initial basecoats getting rid of all the clear. Wet sand lightly with 600 and...
Ground out one plug wire at a time. If you can isolate it to one or two cylinders then maybe you can get somewhere. I'd start looking for...
Strip it. Even if you think it's repaired it will probably ghost through in a short time. Unless you bake the panel, wet-sand, seal and respray....
I did as you asked and it blew up. Now I got headache. Done with helping people......build your own motor
The 1980's were the "Made in Taiwan" era. Speaks for its self.
Try these
Plugging off the egr line is not the way to test it. Hook a vacuum pump to it and with the engine running apply vacuum. Should be able to hear a...
Also use a small filter that goes right on the end of the gun (about $6). My guess in your case would be the solvent popping is from the basecoat,...
Good to see another one coming back to life. Give' er.......
Bigger pump pulley.....
Here's a short history of them. http://en.wikipedia.org/wiki/Chevrolet_small-block_engine
I'll give you double what you paid for it!
X2.......also make sure the polarity is correct.
Might have jumped the timing chain. Check valve timing like others have suggested.
Patience is virtue. Nice score.
Who invented the snow ball?
Is Celine Dione a Ford or Mercury?
Separate names with a comma.
The Jalopy Journal
