The Jalopy Journal
Dual Sunvisors Outside Dual Door Locks Cigarette Lighter Chrome Winshield Trim Horseshoe Hood Trim Dome Light Seat Cushion Two Tone Seat...
Working on the T was wondering if you need to run a check valve if the master cylinder is below the slave cylinder.If so what p.s.i would i use...
Haven't got the brake lines all run yet.Just trying to get it right the first time. Does the 72 maverick master cylinder have rpv valve built into...
I'm building a traditional T,I have 46 ford rear drum brakes with 54 ford F-1 front drum brakes.I'm using 67 ford mustang drum/drum master...
Thanks for your response....
Just had king pin bushings installed need to know where the little cup and cloth washer install.above spindle ,below ?1946 ford spindles any help...
Just one of the crew
Was hoping someone could tell me how to tell what year these backing plates are any help would be appreciated....:)
I think you like what you like .here are two of mine.
Take a test light ground the test light check the positive side of coil should be constant power there.crank the engine while holding the test...
Trying to figure out the best way to install wood in a fiberglass tub.Not sure if to build some type of skeleton and to cover with...
Trying to determine right axle length for a 9in Ford. Guy that I got the truck from said he shortened driver side to center housing. Any info...
I just sat here and read all these post and i understand cost to put a sbc in vehicles its cheaper hands down . but i just got back from goodguys...
You guys are great thanks for the help....
Where do you get the formula for the conversion?
anyone who can tell me how many gallons are in a cylinder 9.25"round by 24" long ? I'm making a gas tank and just wondering how much fuel this...
Here's ours we've been working on :)
I fixed the problem if any one is trying as well go to PAINT and IMAGE (Stretch/screw) and 29% tab 29% then hit OK.... Thanks for the help
Having a problem downloading a couple of pictures. Attachment saying pictures to big. I tried making them smaller and can't seem to get them...
Pictures are 2 Big,need help. Trying to get them attached,and posted..:(:confused:
Wheel hits wishbone and drag link when wheels are turn to the left and to the right. Any suggestions? I was thinking about mounting stops on...
what i have is a 34 ford pickup with 41 front axle .i would like to know if there is any issues wdriving down the streetith putting the drag link...
Thanks for the advice on that I'm new here.
Looking for advice on a spring and how to mount it... Spring measures are 40 3/8'' I believe it to be a 42 Ford Front axle... Any advice would be...
Separate names with a comma.
The Jalopy Journal