The Jalopy Journal
2nd vote for Newport. They have many applications.
Now you're gettin' it. Go for it!
If you're talking about the cast iron piece that goes between the block and transmission, the answer is no. Totally different bolt patterns on the...
I have a T-5 behind a 261 with a 3:70 gear and 30" tall rear tires. Sweet combination, except 1st gear Isa little low. Good to get you going in...
I had a radiator shop remove the lower tank, then I cur 2" off the bottom of the core using a band saw. Took it back for re***embly.
What Moriarity said. I've never run a heated intake, although some say it's an absolute necessity. Maybe in colder climates and vehicles driven daily.
No pictures, but I always liked the one I saw that said "factory air".
I have a chrome valve cover. Cheap. PM me if interested.
I considered Steve to be my best friend. We worked together, and made trips th Bonneville and shows together. After he moved to TN, I would drive...
The gear is an interference fit. It's installed by heating it and ,or cooling the cam. Remove the plate retaining bolts and remove the cam and...
Try using the 6 volt starter. It will work on 12. If you don't get carried away and crank it for long periods.
You need to use the flywheel for the 12 volt starter. 6 and 12 volt use different tooth count flywheels.
I just ran the 130 club a couple weeks ago. Model A coupe with a 261 Chev 6. Got up to 118. Standing start 1 mile run. This was my 5th time. Like...
Try Wheelsmith in CA. I talked to them about doing some 50's Chev wheels.
There's also a seal internally on the "bullet" that goes into the tails haft housing. It seals to the driven gear. You may have to get one from...
What he said. Beat me to it.
If it's a stock type headlight switch, GM or Ford, either, the circuit breaker in the switch is bad. Turn them on high beam and it will probably...
We also used a set of towing hubs on the towed vehicle. Or pull the drives haft. You don't want the driveshaft spinning the trans that isn't...
D&D auto electric in Denver can fix you up.
You should consider using the side mounts on the block. Or a bellhousing with mounts. You need some side to side support, not just mounted at the...
Try explaining to someone why I put a six cylinder in my model A. Then listen to the comments about being 2 cylinders short. A few years I was at...
I don't know if your Impala might have a tilt column, but if it does, make sure you check it in all the tilt positions, since the cable moves when...
Any news about the wind storm that came up yesterday? Videos I've seen are terrible.
I belive Canadian Pontiacs used the Chev 6, so you'd be keeping it all Pontiac. I used to service one of those when I worked at the gas station....
I used a Hurst for a Camaro in my model A. Works just right
Check the Borgeson website.
What Gary said.
I just finished a 3200 mile trip in my '47. 350 / 350 with 3:00 gears. Cruises all day at 75 getting 20 mpg with the air on. I think.that's a...
I have used and installed Vintage Air units for over 30 years. The best, far and away. I have one in my sedan delivery that cools so we'll, I...
CAW was cast in Denver. I was told that the address on some of them is an older house with a shop in back. Must have made quite a few since I...
Separate names with a comma.
The Jalopy Journal
