The Jalopy Journal
Hoping for some advice, I have a 700R4 trans in my Model A but it seems to have an issue with leaking where the dipstick goes in the trans. The...
I have had that same radiator set up the 3 years I have been driving it, not a lot of miles on it though
Have not checked but will now, thanks for suggesting that. They don't have many miles but worth looking at Sent from my SM-G975U using The...
I've been driving for 3 years now and just started having the issue, the master was purchased as a kit specific for disc/drum. Just wondering if...
I seem to be locking up my front wheels more when braking than I did last year. Still have same set up with disc front and drum in the rear and...
I tried putting my floor jack under it but I was just tired I think and wasn't able to get the right angle on it to get the top to slide off. I...
I like that bracket but I hope to only do this one time!!
I had to cut the nuts off to where they were attached to the bracket as they were spinning, yes. Now that I have all the nuts off is there a...
Thanks for the replies! I am headed out to pull it out now I have the axles out now, putting new bearings and seals on, is there anything...
The rear in my 31 seemed to be leaking but when I went to tighten the nuts, found that 2 appear to be stripped. Looking online it looks like the...
thanks for all the replies, I am going to put the bolt back on and see if that helps for the time being but plan on replacing the boot
Kickdown cable was lifted a little on the inside, bolt was only finger tight. Is there a boot or o-ring that goes in or would I be ok to put the...
Working on 31 Model A with SBC(nothing special) running disk drum brakes and a master cylinder from Speedway (frame mounted). The master...
looks awesome!!
The issue I think are the brackets for the disc brake setup that I have as that needs the spacer. After reading more on this, I am not the only...
Got one of the steering arms on but the tie rod was to low to go through the wishbone so tried underneath and that is too low. Any thoughts? I...
That was the person I bought it from but I have been working on it for about 6 or 7 years, Something always seem to come up that takes me away...
My issue was the turning radius as well, once I get the new arms installed I will post some pics of how they look. Thought new spindles and arms...
Not many pics but thought I would share where I am at today with my build! Ford 9 inch rear SBC Chopped 3 inches Channeled 3 inches trying to...
Thanks for all the help!! New set of steering arms ordered
That looks like what I need as long as the disc brake adapter plate will bolt on as well. Seems that plate is what is pushing the arm out to far
Do these sit better inside the axle since they are not as round? Looks like that is the key to a better fit but have to ask. Part number...
The steering arm is hitting on the axle so will not allow it to go on. I am begining to wonder if I need a different brake kit
I am trying to put on new spindles and 3 3/4 drop steering arms. Got the spindles on no problem, can mount the disc brake adapter plate to the...
Getting ready to put in the windshield and not sure what all rubber I need to make it seal correctly. I looked at a couple sites but there are...
Thanks guys, that helps a lot!
I just installed a Tanks fuel tank in the 31 Model A Sedan under the back window, the vent tube is ran down thru the floor to the outside but...
Found an original, thanks for all the replies
I was looking at the ones that MAC's and Synder's has, are either of them better than the other? MAC's says USA made so am leaning toward them
Looking to get a windshield frame for 31 Model A, I have found several but not sure who has the best quality for the money. I will be chopping it...
Separate names with a comma.
The Jalopy Journal
