The Jalopy Journal
9834 no dash fresh by me with Holley kits, Yes I have done dozens of Holley carbs in my lifetime. No it is not going back to one carb. Base timing...
Carb is back to stock jets. Yes I went with vacuum secondaries this time. I think it is lean.
Looking for so help. I have a 4 Galaxie with a 390 with 406 heads and a 63 dual quad manifold. Several years ago i installed this engine replacing...
Keep it up I need the Motivation
Looks like great progress.
Sorry about your loss of work Loos like great progress. I actually found a better car for my project. Mine is still not in the shop yet. Cant wait...
[IMG] [IMG] Picked this gutted baby off the internet last year. Made the mistake of sanding on it with my mask around my neck. Got real sick and...
[IMG] [IMG] It had a drop axle in when I got it. Guess I raise the axle above the springs.
Has anyone used an early Bronco drop pitman arm on a straight axle build?
Ok I got these random tie rods with the axle. I think that will work if I flip the axle. I havent had a chance to put wheels on it yet. Think it...
No problems with the drag link hitting the right spring?
Just bought a 60 Falcon that was some one else s Gasser project. They had extended the pitman arm about a foot and was running a stock f100 cast...
Got a 1960 Mark V with a 430. Took the power steering pump off to replace the seal between the pump and timing cover. ( cranks driven roller...
Looks and sounds great. [IMG] Here is mine.
On the camping side. Is there Electricty? Close portijons? Allow generators. Some of us would like to bring vintage campers. Are they allowed in...
[IMG] Installed a 390 with 406 heads into my Galaxie to replace oil leaking 352. Currently running 2 450s but going to swap them out for 600s. Put...
And it looks just as good in person. Grats on the Award.
No, it has a Ford Emblem on it. [IMG] [IMG]
I got a vintage camper I am redoing to tow behind my Galaxie and went to clean and replacing wheel bearings and the grease seal are shot. Cant...
Looks great. Cant wait to start on mine.
Very good thread. Now I have to make up for the hour I spent reading it to go work on my sons Mustang so I can get it out of my garage so my...
Do you have a part number? all I see is 64 and up springs which are wider , correct?
Amazing.
I just tackled a similar problem on a slightly off topic car. I did a lot of hammer and dolly work. Best thing I did was buy a shrinking wheel....
I have meaning (me) sorry for the confusion. Was tired last night.
Made it in the Ol Skool Rodz mag.
Got those heads on a stock 68 428. Got that cranks and block from a stock 67 Galaxie. Looks like a 390 to me.
Would love to see it in person.
I am going to try to stop on my way back from PA.
Separate names with a comma.
The Jalopy Journal
