The Jalopy Journal
[ATTACH] [ATTACH] [ATTACH] [ATTACH] [ATTACH] [ATTACH] [ATTACH] 1950 Ford shoebox business coupe AZ car surface rust no motor or transmission I...
I just don't know what's going to fit any type header is fine as long as it fits I'm thinking of just using block huggers Sent from my iPhone...
I'm installing a sbc into my '50 shoebox can anyone tell me what long tube headers fit best brand model Sent from my iPhone using The H.A.M.B....
Can anyone tell me what headers they have used for a sbc swap into a 1950 ford car either brand and model # or just make model yeAr of car....
[ATTACH]
The sepentine did not look right on a old car I'm planning on aluminum radiator flex fan
I have my 1950 Tudor I pulled the flathead and trans I put in a 302 ford c4 trans crown Vic police drive shaft getting ready to start next is...
I installed a 302 and c4 into my 1950 ford tudor. For now I'm going to keep stock rear and weld spider gears. My question is what drive shaft and...
Long time no post . I have a 1950 ford which I have installed a 302 and c4 soon to be 9 inch rear. I'm starting the little things like the...
engine is bogging when i get on it before it dies. could it be the power valve?
would a vacuum leak cause the problems that i have said.
i thought it might be a vacuum leak since i noticed the manifold vacuum port that i had pluged became un plugged so i put a brass fitting in...
ok so what could be wrong ? whats left to check?
ok this is driving me nuts new fuel pump new fuel pump push rod. it runs fine at idle it runs up to 3rd gear then cuts out stops running won't...
ok then its a bad pump since it works it just doesn't work at higher rpm.
ok where should it line up it had been apart before for clearance problems on another set up so which way should it be set.
i put a new push rod in.
i'm really think the pump is bad i didn't want to go electric but i hate not driving. the one test this pump is not passing is the capacity test...
now it looks like my starter is shot
do you wire it into on position on igntion switch?
i replaced the fuel pump push rod and still no fuel when you get on the motor. only other options is bad pump or cam lobe is worn that fuel pump...
ok fuel pump push rod is 10 inches even
you might win that bet. I took the car out for a spin once i hit 3rd gear that was it started to sputter and run out of gas. I had to crank it a...
yeah that was it. it was driving me nuts just could not understand how it could run then stop like that oh well .
I think i solved the problem I had put a copper line on from fuel pump to carb which i ordered thinking it was correct size. inside dia. is real...
it does work it just stops working i checked all that.
pump is new. is was at 3 1/2 to 4 pressure. for what ever reason it quits running
My 1950 flathead starts up and runs after running for a while it stops and there is no fuel coming from fuel line to carb.the pump fuel bowl fills...
thank you just got one from ace with hex drive
Anyone know the size of the vacuum port on 8 ba holley 94 . I want to get a fitting to block it so i can use a flat top mallory with no vacuum...
Separate names with a comma.
The Jalopy Journal
