The Jalopy Journal
Where were you 5 1/2 years ago when I bought my project?? What a mistake that was!!! You are Soooo cirrect.
I'm going to open the bleeder to relieve pressure ti check if it's that. But I'll probably go mechanical.
I am going to try that.
I am leaning towards mechanical myself.
The brake light switch shown does not work, brake lights on all the time. I am thinking of using a mechanical switch instead. I know a lot of guys...
I was going to wire with one each way so it was harder to mix up taillight and brake light wires. I can do the taillight the way you said and the...
Looks like a good solution to me. Ordered marine bullet connectors.
The connector is a weather pack actually pretty light. The wires pointed to in pic below will be cut when connector is installed I don't think it...
Inexperienced question. I was going to say dumb but someone always says there are no dumb questions. How long a run can unsupported wiring go?...
It's silicone rubber. Think of it as a long grommet protecting the actual wires from rubbing on a couple of sheet metal edges. Overkill maybe.
It's the picture . Three wires slide eight through. It's 5/16" id.
Running wiring to a '39 Ford taillight. I'm trying to figure out how to get the wiring to the light. The previous owner, I bought a partial...
The picture is of the front side glass for 1939 Ford Tudor. I need similar measurements for the rear side glass. I have the channels but they...
My brother had one in his '56 Chevy conv that held somewhere around 6-10 records. It was chrome. Worked ok if I remeber.
[ATTACH]
I should have mentioned the BP is 5x5.5 not wide 5. The brakes were converted to Bendix by the PO.
Do 15" rims, proper bolt pattern of course, fit on stock 1939 Ford drums?
That is how we did it in a bike shop where I worked in 1971.
They shouldn't allow T-buckets in car shows. About my T. It was the first show I went to.
I did a bicycle seat about 40 years ago with spray adhesive. The naughtiest is still stuck.
That's part of the problem there are a lot that look just like that. Apparently the difference is isolated or grounded case. That is grounded case.
Neg ground.
I have a '39 Ford converted to 12v with an 8CM engine. What starter solenoid do I need? I searched and since they all pretty much look the same, 4...
You've come a long way from your T. Not that it was bad of course.
Jerry you continue to impress!!
Next project trophy room?
I am anxious to see it. Maybe at a cruise around here. Wheels of Time in August?
[ATTACH] [ATTACH] A little space would be nice. But at least it's inside.
I hope to not remove the engine but if I must I will. The engine does need painting. Thanks
Posted on another forum so apologize if a repeat. My '39 Ford hood hinge mounts are bent. I tried to fix in place with c- clamps which helped but...
Separate names with a comma.
The Jalopy Journal
