The Jalopy Journal
Thanks for the explanation and I am learning allot. However I had the frame built by a reputable car builder so I assumed the caster was set...
OK... to the best of my ability using an angle finder of the front surface of the axle I am measuring 12 degree's and the floor has a 2 degree...
Sorry, when I wrote this I didn't realize the post was 14 pages long. The tie rod is behind the axle and the steer is fron to back.
Hey guys I am having the same exact problem hence my reason for checking this post. At low speed only, when hitting a bump or whatever my front...
OK, here's where we are...today I replaced two of the "roto" type needle and seats with two used "old style" needle and seats from a couple Holley...
Hi OJ, Thanks for the offer, I know exactly where Berryville is and the next time I'm headed in your direction I'll see if you are available and...
Hi Guys thanks for the replies. You are right flathead31coupe I have the roto type. I have never seen these before so this is my first experiance...
OK, I took all six carbs apart and reset the float level on the four outer to 1 15/32" and the two center to 1 14/32. I blew out the needle and...
Thanks for all the responses. I am using a new holley low pressure regulator and I have a low pressure guage mounted in the fuel log so I am...
Thanks for the replies. I checked the floats and they seem to be ok, no fuel inside. As indicated they are currently set at 1 12/32" what should...
I need help! I have 6 holley 94's on a 671 blower on a sbc and they are all operational. They were all freshly rebuilt by a "professional 94...
Separate names with a comma.
The Jalopy Journal