The Jalopy Journal
It's gotten bigger, since it was moved 3 yrs ago. I go every year but I'm only 20 min away. It's okay , got some deals in the past. But not huge...
I'm in southwest Pa . Near Johnstown. But I could travel for someone who does good work.
Does anyone know anywhere that punches louvers in Pa ? I have a set of hood sides i'd like to get done. I'm thinking arround 4 inch on yhe...
In my daily driver my crank gave up the fight. It is a 98 gmc , vortex motor. In my stash of junk I have a low mile motor out of a 84 both...
My valve was easy to tell that it needed replaced, I blew air through it with my mouth and it held no pressure. Not a good test, but it worked, I...
Worked on the truck last night, this what we found. First in between the mc and vaccume booster was an adjustmentrod and jam nut, anfter setting...
Sorry by slide the tires, I ment lock them up. And also when I switched the lines at the mc the result was the same, great up front and nothing at...
I'll try ditch the the residuals, and make up some small jumpers.Then I counld always replace em. The reservoir is under the floor about 1 1/2 '...
After I put the kids to bed , I'll sneak to out to the shop and do a investagation, and I'll post my findings, I'd be happy even if I made a dumb...
The pedal feals firm only at half pedal, but at that I only have front brakes, and the front will slide the tires, also no thru the frame...
When I switched the ports there was no change the front would work fine but the rear will not . Also I have rechecked the brake assembly before...
If the brakes are pumped up there is no change, also I haved jacked up both ends and bled them.. It is only my rear wheel cylinders that dont...
I'm working on my 39 chevy truck. It has a comero clip with disc" up front and a 8.8 mustang rear with drum's. I used all new factory correct...
:cool: Defenately cool, I was hoping for a little info but this many souces is great. Still got a lot of cleaning to do, and I also got my pap's...
I was just cleaning out my grandma's house and I found old Stock certificates , both preferred and commom. Don't think I would sell them I was...
Well I'm think I'll go with the stock gap so I can just use stock splash aprons. Because I'm gonna go full fendered , just because there are not...
Ya this is a huge help, I was thinking the space was a lot larger than that. So after work tom I'll get to work and drill some holes and mount the...
Hopefully this is in the right place. I'm working on a 39 1/2 ton and I shortened A frame from a 1 1/2 ton truck, and I'm getting ready to mount...
Hey welcome Jim I'm a newbe my self from The southwest side of Pa, close to where flight 93 went down. Where is the show that you mentioned at...
Separate names with a comma.