The Jalopy Journal
Progressive. I have tried it different ways, but when I open the center carb all the way, the outer two are barely open.
Offenhauser Pacesetter intake with 4 rebuilt holley 94 carburetors with velocity stacks, Vintage Speed linkage. Fuel block and stainless steel...
Hello, I have a 3x2 setup with Rochester carbs . I am having trouble figuring out the connection from the center carb to the rod connecting the...
Thanks for the info. That's a great looking setup. My buddies model a is in my garage. We just put a 55 t bird 292 in it.
Thanks, I'll contact him today. I don't want to bug him, is he OK with calls from strangers? Lol
Stock fuel pump. I do have a regulator, and it is set on about 3lbs .
I have a 4x2 setup on a fresh build 327. The carbs are rebuilt holley 94's. I can't get the engine running right. After running it a few minutes...
I have a Offenhauser pacesetter 4x2 intake with holley 94 carbs on a Chevy 327 fresh build, mild flat tappet cam, I was wondering what jets would...
I am getting ready to Weld Spring perch brackets on a newer rear to mount the Model A buggy Spring. I was wondering how to space those brackets do...
Is a great looking setup. What carbs are those? Also where did you get your linkage? I got mine from Charlie price at vintage speed.
They are about 25 to 30 minutes away from me so not too far. I've used them from time to time with great results on machine work. Had no clue that...
Thanks, I'll try that. I didn't think just the gravity feed would be enough to supply those carbs, but I'll find out.
Good advice, Thanks
I bought the low pressure one from Holly it adjust from 0 to 4 or 5 lb I believe but when I crank the engine over it goes up to about 6 lb or so...
Stock GM mechanical pump I've replaced it several times just to be sure that wasn't the problem. I can't get the fuel pressure below 6 lb and I...
I bought a holly low pressure regulator with a clay Smith gauge that screws right into the regulator it is mounted on the firewall very near the...
You're right, and I do not have a shut-off valve right now so I'm going to install one on the a tank like it used to have. Is it possible...
I have a new Holly fuel pressure regulator on the car but can't seem to dial it down below five or six pounds, not sure if I have a bad regulator...
I haven't even been able to run this car long enough to do a lot of checking it runs a few minutes and then just fills up with fuel and shuts down...
Does anyone have any recommendation as to what is the best carburetors to use when running a four Deuce setup? I have a set of rebuilt Holley 94s...
Yes, on the 4x2 set up they run in unison. I had a 3x2 setup that was progressive and ran great.
Thanks for the advice, I noticed that there wasn't a lot of choices of intakes out there for the 4x2 setup. I'm thinking I have carb issues, I...
I have an Offenhauser 4x2 intake with 4 new Holley 94 carbs on a completely rebuilt Chevy 327. I have checked and re checked the wiring, timing,...
I have a rebuilt 327 with a crane 350 horse cam just put on an offenhouser four deuce intake along with four brand new Holley 94 carbs. I turned...
Car is sold.
Runs and drives great. Just had all four wheel cylinders and brake shoes, brake lines and hoses, fuel lines, replaced, has new speedway motors...
All steel body. 354 Hemi,rebuilt.Weind I take with 2 new Edelbrock 500carbs. I have all paperwork from machine shop. Rebuilt 727 automatic...
Separate names with a comma.
The Jalopy Journal
