The Jalopy Journal
We will be there from New Zealand, would be keen to go to a meet and greet.
Going to Calgary and Vancouver, rest is pretty much open ended we will make it up as we go We are going to a couple of Good Guys runs in the...
We will be out from New Zealand as part of a trip up through Canada. Would like to catch up with other Hambers
Any decent sheetmetal shop could fold you up new bars, save yourself time and trouble
I would not recomend brass for a car fuel tank, joints would have to be lapped riveted and soldered or seamed and soldered. Could be gas welded...
3" nail cut to suit
Send it down I'll have a look
[ATTACH]
Hi Brian, I made mine from a Mitsi ute bench seat, some of them have a folding back See you at the Nats?
Iv'e welded chrome wheels before, used a stainless steel arc rod. Didn't grind anythink back, did a few sets never had a failure.
I did the same conversion in the early 70's, had the Chev flywheel drilled for the Ford long pressure plate, check the bellhousing on the...
Used a Morris Minor front torsion bar on my roadster, worked like a charm
I have the motorcycle magazine with this article in it ( somewhere ) the v max had the roadster over the start but ran out of steam and the...
Look at the vh44 remote booster and just boost the front brakes
In response to the acetelyne generator, I have two of them that date back to the 40's, the biggest problem is getting the granulated carbide to...
I have done this before on an F100 tailgate by sweating on the letters with solder, similar to body soldering worked perfectly.
This is my 1935 Willys coupe restored about 20 years ago and has done very few miles since. Interested in the saleability of this car. [AT...
To do this job properly you must remove the filler completely from the tank, clean both sides back to bare metal, re tin them, rivet the filler...
I have had a pair on my 34 Roadster for 33 years, ride is firm
In my 32 5 window I have a 72 ford master cylinder which has a 1" bore. While it stops fine I would like an easier brake pedal. Leverage is the...
AC
Didn't know anything about Lefty O'Douls until my Wife and I stumbled across it one Friday night looking for something to eat. The place was going...
Merry Christmas from New Zealand [ATTACH]
There is no need to melt down old door handles, you can buy proper die cast welding rods
I had a similar problem on my stock willys Coupe. The fuel would dry out back to the tank and the mechanical pump had trouble picking it up. I...
Put a thin sheet of rubber under it to get it working quicker
Does anyone here have any experience running con rod and main bearing nuts other than castellated nuts and split pins?
Looking good we will see you at the Nats?
How is the certification going? Just asking for a friend
Separate names with a comma.
The Jalopy Journal
