The Jalopy Journal
Trunk Lid for 1946/48 Ford 2dr sdn including hinges Great condition no rust or dents and the hinges are tight $30.00 contct CAL 5592460887 Leave a...
Speedo, fuel, volt and oil complete all work great I went with after market Contact Cal elbroko1@msn.com
Thanks for all the help guys got it covered with PER M TEX Rust Treatment worked great.
I found a small area of rust on my fire wall where the heater valve was I'm replacing the insulation on the fire wall and would like to stop the...
You will find hens teeth before you find a lens cover I'm looking as well and if I come across any I will let you know go to the 54 ford club webb...
What's the best underlay to use to control fire wall and floor board heat
Welcome from Sanger
Flying into Charlotte NC Tuesday for a 7 day tour anything happen in the area No plans on travel just going to run around and do the tourist thing
Don Thanks
What or the #'s for alignment for a 2dr sedan
Grind the center out to pass over the axel hat if it is close if not have it machined
Doc I used a NAPA NRP 22-108 Sag pump I have used this pump with all my rack convertions both Mustang & GM and have not needed to adj the...
Looks like a Thompson Style Pump you said you bought a new pressure spring for it and it uses a spring cut a ring out also ford used a GT pump...
Gerry The pump you are using is it a 56 or newer I understand your using the 56 ram. Yes trim the spring the stock ram requires only 900 psi a...
Later Ford Pumps have a pressure valve located in the pump located under the high pressure connection (unde the 5/8-3/4 nut)You have to remove the...
Has anyone installed a Quatz Clock kits easy/hard??
Do you have the dome light covers elbroko1@msn.com
Has anyone used or own a RHINO welding helmet i'm impressed with the large view area. Let me know what you thank.
If you have the orginal cable look in the yellow pages for a CABLE CONTROL who can make your cables. I have used a local guy here to make both...
I'm missing the small trim piece on my 54 VICKY that joins the trim around the inside rear window on the drivers side, it has one screw hole my...
I would like to have a VICKY model if it's not to much trouble contact me at elbroko1@msn.com I will cover all expences if it's a pain in the a--...
OlDawg I used 5/16x25' Aluminun SUM-G2516. I have used the steel for brakes little easier to work with and as strong and both flare single and double.
After looking at it I went with the coil llne from Summit went great a lot better then using brake line and you can use flare fittings and a lot...
Hey guys whats the address for TOM's Thanks
I have a vac fitting you can use send address and I will mail it to you.
Going to replace the fuel line, tank to pump. I don't like the routing of the line as it leaves the tank over to the frame because of the exhaust...
Separate names with a comma.
The Jalopy Journal