The Jalopy Journal
SOLD!!! I have a Ford 9 inch rear end from a 71 bronco for sale. Factory 4:11 gears and limited slip. 58 inches wheel surface to wheel surface....
JMel, When tuning, keep in mind that the accelerator pumps only give you a SHOT of fuel when you open the throttle plates. From there its all...
Setting things straight: 31Vicky is dead-on right about the accelerator pumps. I was thinking about power valves base on past experience on...
You can split the top/bottom on those Rochesters and silver solder the idle circuits shut (front and rear carbs only).
I wouldn't run three accelerator pumps with progressive linkage if it is truely set up progressive. You idle and start off on the center carb....
You are running accelerator pumps on all three carbs? This doesn't answer your questions, but if you are running progressive linkage I would...
----------------------- Exactly. One fibre is all it takes. Long term exposure increases the odds that you'll get a fibre into your lungs....
I do not want to chop the front, and chop the rear only 1.5" so there's a very slight slope (see picture where i taped the stainless in its new...
(Thumbs up)
The panel below the grille, behind the gravel pan, is different 42-46. The hood width is different where the grille meets the hood, but it will...
Like others have said, these things are prone to cracking. Most common area is between the intake and exhaust ports in the block at the...
--------------- Hey Ron. That was my dad and I walking back with you on Friday night. I should have asked if you were on the HAMB. Nice talking...
I missed it but Lea from Stillrunnin told me that she saw it happen and it was a 360 for sure. Mike, since you are on this thread it can't be...
Check with 40panel348. He's done it. ----------------------
I keep getting comments back as well, Lea. Still Runnin really came through with the latest issue, and it was an honor to have my dad's 60 Chevy...
------------------------- Just to clarify, not true. To put 351W heads on a 302 block you buy ARP's stepped head bolt kit made for the...
--------------- Thats how I do it. And 1/8 to 1/4 turn past zero lash on hyd lifters.
A popular upgrade to the 302 is to put 351W heads on it. So popular that ARP actualy makes the stepped head bolt kit to fit the 351W head and the...
Fenderwelt is a must for a restoration, but be are not talking about that here. If I was building a show-only car and it was not built to look...
Thanks everyone for the information on the rear. I am working on buying the whole setup, chassis and all. I may use the rear in a future project...
Aaaaaah, so they DID use the rear to make a quick change. Someone earlier said NO. Good to see your reply and find out how it was done. Thank...
Depending on the tire size used and overdrive, to each his own.
Just wanted to share with anyone that followed this thread that I got an email reply from someone on the early ford forum and he added the...
I could probably get it all really cheap, but I don't need extra "junk" laying around. I have pleanty of flatheads as it is, but then again one...
I came across this (46-48?) Ford heavy duty truck chassis with running gear. The motor is a 59ab and turns over by hand. The owner said that the...
Go to http://www.vanpeltsales.com/FH_web/flathead_home.htm and click on flathead identification in the menu on the left of the page. It has all...
We made some of those oil, gas, water cans up for a show-kustom project and we used old paint thinner cans. I don't know if that is what you are...
Separate names with a comma.
The Jalopy Journal