The Jalopy Journal
Offers?
I'm looking to sell one of my 4A Marchant air powered shrinker/stretchers. It works well with minimal air leaks. I will include 2 new piston cup...
Not mine, but T body, A gas tank. [ATTACH][ATTACH]
Adam, Is it something like this you are looking for for two filament bulbs? [ATTACH]
I'm not affiliated with any advertisers, but this is basically what I used for a 350 Chevy engine in my 36 Dodge. Top center port and bottom...
Sold
Greg, Here are their instructions: [ATTACH] You will still have to cut and adjust to fit, but it gets you about 95% there. If you need...
As I remember, I used 35-37 Ford truck channels. The back channel is deep so when the window reaches the top and then slides forward, it is still...
I agree with F&J about a single front pivot point being the best (if not possible than be as absolutly close together as you can to minimize...
SOLD, Thanks
Jim, Is the picture you posted a picture of the actual car you bought. The picture you posted is a 35 Dodge. Or did you post a picture of a 35...
Jim, That is a 35 Dodge 2-dr sedan. It should be a one piece back window not a split window, check again and get back to us. The trunk lid will...
Not Mopar. Mopars have a separate catwalk area, and no crease in the rear fenders. Closer to '36 Chevy except for the headlight mount. Make that...
I'm using a Johnny Joint from Currie for the front pivot in the rear of my roadster. I am using an open drive 47 truck rear (hope to use a quick...
Older car is 1935 Plymouth.
sold
Mine coming together. [ATTACH] [ATTACH] [ATTACH]
Scott, Sorry they are not the same. The grill and shell will be the same, but the mount is very slightly different. Hope that helps, Bob
Bob, Measure the height where the axle will fit. if 2", then it's 35-36, if it's 2 1/4", then it's 37-later. Bob
It's a 1929 Dodge Standard Six. I had one years ago. Hope that helps, Bob
SOLD
Mark, Soooo glad to see you back on the 34. That's progress, and it's not an illusion! Hope to see it in person soon. Keep at it, Bob
Mine is 36. Yours doesn't appear mirrored to me. 36 is splinned shaft for handle whereas your appears square. I'm not sure what years were...
It should bolt to the cowl under the windshield. You should be able to work it, and adjust it to work the windshield, AND THEN when satisfied,...
Check this tread out. https://www.jalopyjournal.com/forum/threads/what-is-a-perfex-thought-this-was-model-t.934038/ [ATTACH] [ATTACH]
I've had a few of these aftermarket 36 grills over the years. They aren't as nice as an original, but function the same. They are installed from...
Early aftermarket replacement grill for 36 Plymouth.
Captain Morgan and ice cubes would seem like the logical next step, in the name of science of course.
The head matches up to 1936. Bob [ATTACH]
Separate names with a comma.
The Jalopy Journal
