The Jalopy Journal
I have a limited budget for a limited use item. I need a cheap paint gun. I need to prime my car and paint with some satin/low gloss black. I was...
Thanks guys, if the Argon/CO2/O2 mix is for cosmetic reasons my welds are really in trouble.
Ok, I was welding on my floorboards last nigh and ran out of gas on the mig welder. I have had this welder since 1994 and I think I have filled...
(You have insufficient privileges to reply here.) Why is that at the bottom of all of the classified ads that I am interested in? (You have...
I have recently got my project car running, well sort of. It cranks and cranks but doesn't start until I release the key. I can crank it a lot or...
I only got a small block Chevy in it but I still hope to yank 'em up some. I figured a little stiff was good but I'm sure its quite a bit too...
I built a 1960 Falcon with a Speedway straight axle kit. The front leaf springs are way to stiff and I would like to remove one or two leaves to...
I had those sliders on my IMCA dirt modified race car. Worked great. I'm sure my car had alot more suspension travel than a street car so I think...
Looks good, I like 'em.
Well, I found the problem. I finally got time to work on it today and upon cleaning up the aluminum oil pan I found several cracks along the...
If ventilation is an issue I can put the grommet in the valve cover with a pcv valve but where does it hook on the intake or carb. It has a tunnel...
I wasn't blaming the pan. I would like to use it. I like the looks of it plus I don't have a stock pan. Oil comes from three of the bolts and runs...
If it's a ventilation issue wouldn't a stock pan do the same thing?
uh oh? It does have sealed valve covers and no pcv valve but the intake has the breather stem on the front of it. Is that enough? The gasket...
I did check. I ran a tap up into the holes and the tap goes farther than the length of the bolt. I am using the bolts that came with the pan, I...
It has a huge oil leak. It is a '60 Falcon with a small block Chevy. It has a cheapie finned aluminum oil pan. When I started it oil ran out of...
WOW, I really like that. I just opened a small sign/vehicle lettering/wraps shop and I need one of these for my shop truck. Awesome!
I did think this would have to be custom made. Thanks to you guys I will now go to Autozone and just pick one up. Thanks to all!
I have a '60 Falcon I am working on and I'm ready to put the windshield back in. It has the stainless trim that fits into a groove but I have...
Thanks guys, I will go with the volt gauge.
I am looking at the under dash triple gauge kits and I see some have amp gauges and some have volt gauges. Which would I want for my street SBC...
A 5/8 fine nut screws on nicely.
I am building a 1960 Falcon with a small block chevy and a 4 speed out of a 1979 Trans Am. I would like to use the stock speedometer. I do not...
that's what I was thinking. Looks like a great start for us in the mid-west.
I like them both!
I kind of like mine with the fenders off.
I see your pics.
WOW, That sounds good.
pm sent
Separate names with a comma.
The Jalopy Journal
