The Jalopy Journal
Olds 394 block with crank in it. Unknown condition but was bought from a machine shop closing up. Ford banjo rear with wide 5 wheels. Very rusty...
So haven't been on the HAMB in quite sometime. Lots of changes here . One thing I've notice is a severe shortage and lack of traditional car...
I recently discovered the headband headlamps (I know behind the times).....i thought i died and gone to heaven. The light is everywhere you...
Thanks for the help!
My dad just bought a 57 Ford. Y-block, 239. Has the original carb...2 barrel. Its running rich and fouling out the plugs. This carb looks like...
Have one in my 50..no room for mechanical fan. As already stated...good wiring and relays....and i upgraded to a 120 amp alternator. Its the...
Thanks for all the replies...popped a 160 thermostat in and it still pegged the guage..just took longer..water in the radiator is swirling around...
So I have an OT vehicle that originally had a worn out 300 Ford inline six..use 2 quarts of oil a week. I found a complete 289 from a 67 mustang...
Will 37-41 Ford spindles fit on a 56 Ford f100 axle? Are the kingpins the same and camber angle the same? Thanks!
Im installing new control arm shafts on my 1950 ford shoebox.....the old ones were a real bitch to get off. It looks like the endcaps just screw...
lemme guess, "nothing is for sale"
Little bigger
Driven everyday, everywhere, my truck is down for repairs and its all i have.
get it fixed yet? I went through this same problem with pertronix. It wasnt the pertronix itself it was a bad ballast resistor!.....it ran like...
Ok...it has been my expierience that a good mechanical clutch fan with proper shroud is THE BEST! Never had overheating with a factory setup....
Hey what is that old factory behind the Moultrie alternator service building. I like old architecture, and I pass that Moultrie alternator...
Sounds like fun!...I will bring something, charcoal, food for the grill, or beer. Money is tight but im not a freeloader so I will contribute! So...
So Id like to drive my heap there. If I bring a tent is camping allowed Sat night?
My 50 is squeaking really bad in the front. I lost my service manual some years ago and I was wondering if anyone could scan the section that...
btt
Please help! I used old glass from another 50 for patterns to get new glass cut. New gasket lip will not pop all the way around pinch weld when...
Well thanks for all the advice. See they give you whats called a bench test...you have to replace brakes, set timing , test electrical system,...
Hopefully this is not off topic, its not about traditional hot rods and customs but it is about the work we do on them. I am a letter carrier for...
Yeah I should have posted this on the original thread. Sorry everyone! moderators can close this one if need be.
So when does this start tomorrow, thinking of ridin up. Would like to run my shoebox but no seatbelts. So what time should I get there to see...
Thanks for all the replies. The engine is in an OT 69 corvette. It starts up and runs fine just quits when you touch the gas. Will check some of...
bump
The engine is a 1969 350 chevy. Has a quadrajet carb, new fuel pump and filter, new points, condensor, new coil. Problem is engine starts and...
The car is a shoebox ford 1950 that runs great. Just a horrrible ass body, there are replacement panels available I think I could learn a lot on...
Well I havent even got to the other side yet! so there is probably more to come, wow gotta go get that beer now. Some bodymen should be...
Separate names with a comma.
The Jalopy Journal
