The Jalopy Journal
I said I wasn't going to do this, but here are my bulldogs. The white one is 10 years old, we call her mama, her name is daisy. she IS fancy! she...
The inside of the intake bolt holes are going to be covered as well as the top surface. Your going to need to get some clean metal somehow. Maybe...
Test the intake to make sure it is grounded, I know that sounds stupid but is a long shot possibility. If the fan comes on with the toggle switch...
I've had good luck just putting an inline oiler in front of the compressors
Maybe you could use a factory type muffler after your magnaflows to get your paperwork? then take them off? Don't know your laws, can they test...
#5 says no superchargers. Does that mean NO forced induction? Or just superchargers
This guy is my mascot,best friend, security and helper. If I could just get him to hold things for me.
uh.......shackles.......hello
'52 chevy
If you hav'nt welded alot of sheet metal, get you a couple of flat scrap pieces and get an idea of how to go about this. It does take some time to...
That changes the whole look of the truck, nice decision. I agree with the chrome bumpers, and the fade on the wheels. You have to do something...
Damn spammers!!!!!! Not you Rocket Ron this guy ^ ^ ^ ^. Welcome to the H.A.M.B and enjoy the endless mayhem and knowledge.
OHHHH, I see that now. Maincaps slow you down anyway.
Wait is that the flywheel/flexplate? I think the whole damn crank is on the floor.
The way I do rear mounted batterys is to drill a hole through the floor, attach the ground cable to a bolt going through the floor, then attach a...
if you don't have a slip yoke put a surgical glove or a couple of balloons over the tailshaft. you can even cut up a water bottle and some tape...
If your going to "fix it up" then just rebuild the engine, then you know what you got. Could the seizing be why it been sitting? If you must...
I hope this helps
While your opinion is that I am pissing away money and breaking parts left and right for all the wrong reasons, to me it is all worth the price...
you can cut the column in two pieces, the outer column shorter to expose the actual shaft. Install a bearing over the shaft into the column. I...
fill it with gear lube and quit trying to build/drive a hot rod till you're through with school and employed. Dave Damn! Captain Buzz-Kill. Put...
That is for sure something your going to have to play with at the track. If your wheelie bars have the springs in them, you can set them a little...
grab the car up,if you don't build it then it's a good investment for you. You can build it later on, or trade it for something more complete?
It's only worth like.............. 50 bucks. Tell you what I'll give you a hundred cause I'm a nice guy.
BLANK? Uh, now I'm lost. Is it cleaned off? let me do some searching.
I do not like you right now. Jealous.
on the passenger side of the block, right in front of the head, there will be a flat surface run the numbers from there it will give you more info.
Went to the oreily's the other day for a few things, walk in and the only one at the counter was a girl. Couldn't have been out of her thirtys. I...
you beat me to it. the pcv does'nt have to be seen as long as it is installed where it can evacuate the crankcase as long as it can't get it's...
I know we are spending to much time on this, but what did you google to find it?
Separate names with a comma.
The Jalopy Journal
