The Jalopy Journal
Or you can make your own.
Better than the other way around.
I listen to Beethoven's Ninth symphony. I figure if a deaf old man can build that all by himself... I can build anything.
Not picture I took, I think I found it on the HAMB years ago.
I don't have a pic available but I run one on my 1940 flathead. Vacuum source is from a spacer between carb and manifold that was originally used...
They towed the Chev's in.
Born in 1945, I can remember gasoline on special at 19.9 cents a gallon. That's fill 'er up for under $3.
Do you want multi-disc or single disc clutch bellhousing?
I have over 10,000 miles on mine. Used shell bearings on mains and rods in a B block but it has never given any trouble.
I am running one. You will need to get a puller to lift the pinion out of the diff, unless you plan to dismantle the diff, which is the hard way...
Here is my 1928 Special Coupe in the middle of Australia, and the engine that took it there, one of three trips across the country in it. The...
Which makes Henry Ford the only manufacturer that didn't take part in the idiocy.
Does the board stopping it from rolling down the drive come with it?
Or make your own.
I am running a banger with a Weber but have also run a Stromberg 48 and 97 on the same manifold. There is definitely not enough pressure from the...
Dash colours depended on whether the car was a Standard or a Deluxe, nothing to do with the colour of the car. As mentioned above get onto the...
Thanks to all who responded.
Negative Ground for 12V.
A worthwhile addition for sure. Not to be a picker of nits, but after selecting a prefix to a new thread the prefix selected appears after the...
I have a very good four cylinder Vertex Scintilla mag, which it is configured to work clockwise (looking down from the top). Does anyone know if...
This engine looks a bit cluttered but has crossed Australia three times. B block, counterbalanced crank, Lion Speed Head, Weber 32-36 carb, 34...
See this for one of the most famous car advertisements ever. http://www.charleswelty.com/authors/jordan.htm
Shell makes some Semi-solid Grease that is ideal for this. It looks like chassis grease but actually flows (slowly) but does not run like 600W.
I used a 6:1 Winfield reproduction for a few years. Had trouble keeping the aluminum head sealed to the cast block. Changed to a cast iron Lion...
I have used the Carter Rotary pump and Holley low pressure regulator with no problems over the years. Beware the made in Mexico solenoid type...
Use the low pressure Holley regulator, range is 0-4 psi. You will need a temporary gauge in the line as the regulator must be set with the motor...
I recommend the Carter rotary fuel pump mounted of the inner frame. Work it through the Holley low pressure regulator mounted on the firewall as...
I am still running a 6v redtop I bought in 1998 in a 40 Coupe. Thats rising 10 years.
I would just like to add that when I bought my calendar I inadvertently sent an extra $3 via PayPal. This was credited back to my account without...
I left 41 years ago, nothing appears to have changed.
Separate names with a comma.
The Jalopy Journal
