The Jalopy Journal
Black Mountain is about 10 minutes outside of Asheville. Bout a 4 to 4 1/2 hour drive from raleigh.
New location for the 2011 hellbilly hootenanny: Shovelhead saloon 2898 u.s. Highway 70 in black mountain n.c. Check the website: Bootleggerscc.com...
*please note* the location for the 2011 hellbilly hootenanny has changed. The new location is at the shovelhead saloon. The address is 2898 u.s....
Good deal! We look foward to seeing you guys. Your show was off the hook this year! We had a blast!
The 3rd Annual HELLBILLY HOOTENANNY September 24th 2011 at the SHOVELHEAD SALOON 2898 U.S. Highway 70 Black Mountain N.C.
Thank you to everyone for the advice, it is greatly appericated!
with the car on jack stands on the axle housing, i have 1 1/2 inches of yoke coming out of the transmission....
does it matter how the car is sitting? jack stands, etc.....
When measuring the drive shaft, how much of the yoke on the transmission should be exposed? "play" the car is on two jack stands that are placed...
what about grease for the ring gear before i install it back?
Curious to know what type of gear oil and grease for the 3rd member should be used for a 1950 ford shoebox?
Trying to figure out what kind "brand" of rear axle i have in my shoebox? the numbers on the housing are 8A 4025 with a tag above that has 122....
About the sanderson headers...I have a set of the cc2 and a few others that were trying to make work for my 50 shoebox. We are still having issues...
which set of sandersons are you running? And on what? thanks..
Looking for a set of headers that will fit my 50 shoebox that houses a small block chevy motor?? "dump toward back clearing the steering box and...
I'm looking for an altenator bracket for a small block chevy motor that mounts on the passenger side? (with a short water pump) this motor is in...
do you have any pics of the installed radiator?
small block chevy motor in a 50 ford, Curious about the mounts available for this application for a radiator? i have 24 inches by 24 inches of...
how do you replace the staples that hold the felt window trim? Is their a speciatilty tool? :confused:
are those a stock gm brand or aftermarket? where do they dump? in the center or the rear?
I'm trying to figure out what header will clear the steering box in my 1950 shoebox that's housing a small block 307? Any help would be greatly...
hey man, i'm running into the same problem with exhaust for my 307 what did you end up with for headers?
Need help. i own a 1950 ford car, i'm getting ready to put a 350 small block and tranny in it,i'm curious about the tire rod clearence with this...
Separate names with a comma.
The Jalopy Journal