The Jalopy Journal
On the dyno I hit 140mph in 13 seconds on the graph I can get a chart from the shop that shows that we don't have a track near my local and the...
Yes fully synced with my synchrometer and shops sync both read the same across all 8 barrels and no drop before we ran on the dyno
Me too lol I know I've read lots about webers on fords and chevs and vws putting down decent numbers on the dyno so I know I am losing somewhere...
But yah I'm picking up what your saying I've been told 42mm from a guy on the gt40s site since that is where most of the weber folks hang out and...
The dyno cost isn't that bad my buddy runs the one I just went to so I get a little more play time then the average customer
Half turn on each from full seat verified the floats even used the Gunson colour tune on it which shows me rich however I'm not going to jet...
Yep lol
No load just messing around in the garage when it really picks up and same with dyno that's when the main circuits are in full effect vs the idle...
https://instagram.com/p/urredgx9_Y/ Doing 100mph
https://instagram.com/p/5QPadbx9xc/ Here is a video
Yah I hear yah big deuce and agree with yah on it
The cost had nothing to do with the purchase the issue was I was not given a list of what I was purchasing
Well sorry pat I'm not perfect but I do like to attempt to do things on my own and if I fail then I fail or I try to learn from my mistakes I...
Oh I understand he knows his shit and don't doubt it but I like to know what I'm buying within reasons a simple emulsion tubes jets would suffice...
Yah I called jim basically I give him 300.00 he sends me a mystery package with everything I need for a 383 when I asked him what was included...
Yah the issue is with the carbs I learned from the gt40 guys my venturis are way to small I need ideally 51ida not 48s however were not going down...
I didn't put the cam in that is the only thing I did not verify so I have no idea which cam is in it I did verify stroke and bore and it matches...
Engine specs are in the first post verified bore and stroke when I put new head gaskets in it after I purchased engine vacuum cylinder pressure is...
[ATTACH]
Well redid the dyno and 215hp and 325ftlbs I guess time for some better flowing heads and a new cam shaft laying down 325ftlbs at 2500rpms isn't...
Fuel pressure is 2.5psi its not an issue with the webers I'm running 351 trutrac posi he did the dyno pull in third with an m20 4 speed
No i didn't want to dyno until my webers were close to being functional and then getting an afr sniff so I can be close to jet closer to where I...
The issue isn't really the carbs yah they run rich but they wouldn't account for the low dyno number unless his rpm on his dyno wasn't reading the...
I put a 65 in idle in it after I got home car responds the same as the 70 a little leaner but not noticeable and I was planning on going to 42...
There is two videos on my Instagram listen to the way I rev and listen to it on the dyno
Check me out on Instagram 29roadster666 to see videos of the guy running my car on the dyno and me in my garage at wot there is a difference he...
Oh yah all synced it's not a weber issue I get wot at 6200rpm
The way webers work I'm idle circuit until 3000 rpm then my main circuit takes over usually there is a drop on most dynos with webers during this...
It's on the dyno image I'm rich as fuck where I make power in the idle circuit then when my main circuit I'm perfect 14 afr and he didn't have...
I've taken a lot of my buddies for rides who are blown away with the results who have or have driven in 400 plus hp cars and we can't figure it...
Separate names with a comma.
The Jalopy Journal
