The Jalopy Journal
Selling a few parts off an early Oldsmobile engine I'm working on and won't need.... Pair of exhaust manifolds, previously chromed...they have...
Not sure if this has been accounted for or not....came from an older HAMB member (5quart) out of New Jersey...it's now going to be put to work in...
Thanks for the tip VT...I'm planning on doing that very trick...now time to assemble the rocker shafts, thanks again everyone.
Paul, thanks for the information, exactly what I was looking for. There are grooves on the shaft as well, now that you pointed them out. Can 1.5...
Lostone, I feel the same, the diagonal full width seems like it would oil better...
That's the plan...wanted to see if the angled slotted shaft was for 57-62 and if so if that matters...
Good evening fellas, I'm in the rebuild phase of an early Oldsmobile 303...it will be outfitted with a pair of 324 heads with Isky adjustable...
1926-27 Model T Coupe Body...subframe is in good shape but sheet metal will need patch panels. It looks to have been hit in the cowl but comes...
The photos look great! Excellent work
Quick update: I wound up removing the rear axle from the car. This allowed me to tip it up on end and drive the lower shaft out the rear which...
Agreed....I'm going to pull the rear this week and do it right after all. Once I get things apart I'll decide which way to go....but for now I'm...
The yoke on a converted closed to open drive unit uses the roll pin to hold the yoke in place. This is the roll pin that goes through the coupler...
Alchemy, I've been considering that very thing... my only apprehension or question is would the drive shaft then need to be extended due to the...
That's a good point, I'll have a look at this tonight and follow back up regarding the shaft. Thanks again for the help. Updates to follow...
Also it is the closed drive shaft... Which I have the c-clips off. I just need the shaft to release from the bearings or the bearings to release...
Maybe I'll give torches a try then.... My guess is it was starved of oil while running 80mph for 6 hours after the front seal failed....that's my...
I did yes, came from HRW about 10 years ago...they did the axle conversion and initial setup, I just reassembled when it arrived. I might make...
Perfect! I forgot about Salt flats write-up....it's been a minute but that's exactly what I was looking for...Thanks!
Bummer, I knew the case needed heated to remove the pinion, but was hoping that wasn't the case for the lower shaft bearings... Any chance one...
HAMB, Let me start out by saying I've spent the evening searching the pages of Quick Change threads without any luck.... After coming back from...
Selling a SBC/ BBC Magneto Base that has the tachometer drive hookup....let me know if your interested Ryan.
Late 60's Mopar Steering Box. These make great cowl steering setups. I was going to use this for another car but wound up sourcing a Schroeder...
Bump
BUMP
Ford Pedal Assembly Asking 120.00 ( shipping not included) [ATTACH]
SOLD Hurst Engine Saddle SBC/BBC [ATTACH] [ATTACH] [ATTACH]
Selling a pair of Forged round back spindles these are forged (Mr. Roadster) spindles and were run on my car for awhile until I changed...
SOLD 39-48 Ford Front Hubs. These are in good runnable condition, races are in good shape...they were swapped out for later hubs with Buick...
SALE PENDING Selling my Mcleod Aluminum Flywheel and 10" pressure plate setup for a Flathead. I ran this for a few seasons, it's in good shape,...
Separate names with a comma.
The Jalopy Journal
