The Jalopy Journal
I have Lincoln SP 125 for 30 years . changed one trigger switch . I would tell you dont get one that has 4 heat range switch you will always want...
[ATTACH] Tether car i did a few years ago
My friend had a 3 deuce set up on his 327 . we chased a vacuum leak on it and found we could close of air flow to all 3 carbs and it would still...
Pretty sure this was for plastics that needed more for one reason or another . have used it for that .
I waited 10 months . check posts on here.
The thinners that I used don't seam to be available anymore they make a big part of the job . something to think about .
I have a t frame with numbers they are under the passenger seat . I have been told that the late 26 and 27 . I just went and checked pass. side...
It look like a Kelsey Hayes bent spoke that some one cut the center out of . they where welded I have 6 0r 7 that look the same except for the...
bump
I want to bump this up again . this sucks I hope they catch these guys and run there fingers through the planishing hammer !!!!!!!!!!!!!!!
hi, if you take a strip of plywood a little longer than then you need to get past fender lip drill a hole in one end use a rod or some thing long...
hi, I have a deco/Clinton engine and an n.o.s. set of procession wheels/tires is there a forum somewhere to sell these ? please pm me if so....
Cory, nice car !!! Do those front brakes bolt up to 32 spindles or was there some work that had to be done? Karl
Rick, I'm sorry for your loss . karl
check 51/52 f2. they are 2in. 12 wide self energizing.
when i put coil overs in i try to get around 17 degs. laid in at the top. i also tip them forward a few degs. because your rear end should travel...
winters is in York pa. www.wintersproformance.com ph.# 1 771 764 9844
seekonk speedway oct 27. rt 6 seekonk mass.
Thank's John I never got to leave my vending spot.Karl
It's Dave Simard's shop.
i was looking at your pictures. if you took a 3/8 drive socket that fit tight in the damper.you could drill in the center that way.
There are no words. Gods speed Andy. Karl
hi, did you weld the other side yet? if not check that flair to see how it fits. you may find the center sticks out a little more then than say 6...
I lost a good friend yesturday. George Faulkner a car guy to the end. Hot rods,customs, classics he loved them all. I have to say we had many...
hey, don't forget my house this year
Happy birthday !!!!!!!!!!!!!!!!!! Rich. Karl
Hi, I'm sure i saw a how to in street rodder. It was done at the rolling bones shop. I'm not sure what month maybe someone else knows.
go to mitecars.com
Separate names with a comma.
The Jalopy Journal
