The Jalopy Journal
Loved your article. Ive been building hot rods for over 50 years, and we didn't take it so seriously then. They were just old cars, and more fun...
My 32 roadster has a 59 389 Pontiac in it. The rocker arm studs are 5/16. The rocker arm nuts on my motor are warn out and keep backing off. I...
What is correct sequence to bolt down a steel 32 roadster body for correct alignment?
Mounting new fenders on my 32 roadster. had to trim 1/4 inch off rear to fit against running board. Is there a sequence to follow to get braces...
Will D port headers fit on a 59 389 Pontiac motor Posted using the Full Custom H.A.M.B. App!
I just converted my car to 12v, and I want to listen to music, can I get an amp that will run my phone so I can stream music, maybe bluetooth? I'm...
It's just a real mild custom, just a cruiser. I'm a 20th century guy just wanna listen to the radio!
I want to replace the stock 6v radio in my 52 Pontiac with a good 12v stereo. Anyone know of a good company?
I just put a fresh hydro in my 52 Pontiac, it shifts 1st, 2nd, and then into 4th gear. It will down shift to 3rd for passing and back to 4th. The...
just put a fresh hydro in my 52 pontiac straight 8, it shifts 1,2,4, missing 3rd gear, does that sound like a throttle pressure adjustment?
just installed a fresh straight 8 in my 52 Pontiac, 6volt, good grounds. starter rebuilt, but cranks very slowly so engine wont start. battery...
That schematic does not show director tonal signals.
I'm rewiring my 52 pontiac catalina, and I need help with the signals. There are 6 wires coming from the column, and it uses a 3 wire flasher. I...
I'm restoring a 52 Pontiac Catalina. There is a 4 post switch mounted on steering column on engine side of firewall. It has 2 pins and 2 spade...
can you drive an O/D trans with the solenoid removed or will it leak fluid?
Thanks for the help, jroberts, I think your article will be of great help to me! matt
I'd like to exchange the O/D trans in my 48 Champion for a rebuilt rather than do mine. My trans is fine, O/D doesn't work, and I'm told by tech...
I'd like to put A/C on my 52 Pontiac straight 8. Anyone ever seen it done or know someone who did it?
Thanks guys!
My 52 Pontiac WCD carb is leaking. The fuel inlet is on the back of the carb. There is a brass hex plug in front of it. On the carb body on either...
it just started, runs fine when cold, gets worse as it warms up
I have a Petronix ignition. car cuts out when it reaches operating temp, any help?
Got a Petronix ignition, seems when the car reaches operating temp, it starts cutting out. Bad coil maybe? Any ideas, I'm stumped.
thank you, Jack
Got a model A with a Mercruiser 180 L4, 5 speed, running a Holley 94. I need a better choice for a carb. Is 390 Holley 4barrel too big?
Hi, got a new Autometer electric speedo, hooking it to a s10 5 speed with 2 poleplug. speedo has a 12v terminal for the VSS. I dont have a VSS....
Just finished rebuilding my 48 Studebaker flathead six. I'm trying to decide whether to use the add on oil filter, which isn't full flowing or...
I need a steering wheel for my 48 Studebaker Champion project. Don't make fun!
Separate names with a comma.
The Jalopy Journal
