The Jalopy Journal
[IMG]
This is for my wifes Jeep Grand Cherokee Limited. This particular wheel was the spare that I rotated in. These wheels are very nice and I don't...
Anyone have any ideas on how to remove the green corrosion from chrome wheels without damaging the the finish? The tires are mounted, so I can't...
Update- 3 months and the JB weld is holding. So far so good
I use an Accel Gen 6 ECM. It has its own wiring which uses a MAP sensor. It also eliminates the cold start injector. I'm looking for an intake...
I have the same set-up in my 50 Shoebox. I got rid of the MAF and put a MAP sensor on it. The only problem is when it gets real hot, it stumble a...
Got it, thanks.
I have removed the only bolt holding the housing in, but I can't get the housing out. I've tried spinning it left and right, but its not coming...
Steve, I have 3 wires coming off the tranny, which one gets left out?
You're right, I just read that the lock-up was an option with the Accel ECM. It's current configuration works, but I'm wanting to eliminate the...
My 50 Ford has a Tuned Port 350 with a 700R4 tranny. In its current configuration, the lockout is 1 wire to a toggle switch. It's a manual...
My 50 Ford is leaking a lot of fluid from the speedo cable after sitting. I'm assuming the seals in the speedo housing are bad, however, I have...
Are you going to carry an E6B flight calculator to figure out your ground speed?????? Those guages are only for astetics, I think they look good.
Here's is a pict of mine. It's stock. [IMG][/IMG]
There are finned heads and multiple carb intakes (edmunds, knudsen, cyclone,evans,wilson, and nicson) but they are very expensive. Heads go for...
Problem solved. The new switch was also bad. Its getting harder and harder to get quality parts anymore. All these shity mexican, chinese, or...
I replaced the switch, I have brakes, and I dont see any grounds. I have a digital multimeter, but I'm not very good with it. What should I be...
I have a 1950 Ford with a 12 volt 18 circut painless wiring kit installed. My brake lights quit working and I'm out of ideas. I've replaced the...
Thanks for the offer Never2low, I'll keep it in mind. I'm hoping that I won't have to remove the intake for a while. The intake is off a tuned...
JB weld is holding. No leaks as of yet. We'll see how long it last. Thanks for the advice.
Thanks for the replies. The JB weld is hardening as we speak.
I'm wondering if the pitting on the mating surface can be repaired. It makes me nervous to install as is. This is the water jacket area. Any...
The control arms are the only parts that I did not replace. Everything else checks out. I've double checked the tie rod Part#s. That's probably...
The tie rods are bottoming out in the sleeve. The old parts were a conglomerate of unknown parts. I just put in everything new, steering...
I have a 69 Camaro subframe under my 1950 Ford Shoebox. I just completely rebuilt the front end. Now as I try to get the toe-in correct, I can't...
Welcome from Savannah
I've had a set of Diamondback that were great. I just bought a car with ols Cokers on it. They were nasty, but cleaned up great with Magic Eraser....
Here's my mild custom[IMG]
I'm rebuilding a 1967-69 Camaro sub-frame in my 1950 Ford Shoebox. After tearing it all apart and ordering new parts, I realized that the tie rods...
Separate names with a comma.
The Jalopy Journal
