The Jalopy Journal
I think running ONE fog light is traditional and proper....[ATTACH]
Had mine chromed back in 1984, still holding up well.
SOLD
I have a few leftover parts for Schroeder Steering. A 14"pitman arm, a cut-off input shaft with keys and nut to retain gear, a support bearing for...
Riley 2.5L engine
Mystery SOLVED! It seems my "rocker cover" belongs to a 1949 Healey Silverstone[IMG]
that's why I think it might be VERY early on....
I'm thinking perhaps a VERY early Mercedes Benz.
I appreciate the input. Sarcasm is good.
The cover measures 18" x 4" x 3" tall.
Good morning fellow HAMBer's.[ATTACH] [ATTACH] I'm in need of some expert opinion. Yesterday I was given an old, heavy cast aluminum (seems too...
NOS 1961 Buick taillight lens. perfect condition. P/N TMC-753-RH....This is a GLO-BRITE SAE-STDB-61. Price is $15 plus the ride.[ATTACH]
When I got to the point of making floorboards for my last build, I began looking for a reasonably priced, preferably USED brake. I found one close...
who said I like it clean? LOL My carbs leak, my oil pan drips, my beer spilled...
yes, I think paper will be the BEST way to go.
yes, the bearings are sealed but still weep a tiny bit of red grease. I guess if the caps leak I will clean them up and silicone them with a...
yes, I know all about the liquid gasket alternatives, but is it really needed?
simple question, I just swapped out the rear bearing caps on my 471 GMC blower and realized there are NO gaskets under the bearing covers. Is this...
yep, the only real issue I had was a bad torque convertor, had to go to a higher stall, but that was a calculated gamble. The blown flathead...
I put together my AV8 several years ago and opted to go with a 700r4 behind my flathead. Coupled with a 4:11 rear, the low 1st gear does a fine...
slide a piece of wire through first, then PULL the springs through.
Here's my dirty-one ford.... [ATTACH] [ATTACH]
I use filters for commercial air compressors.
[ATTACH] Go TALL. More surface area = less restriction.
he has mentioned me sending a check, but that's still no guarantee that I get my parts. My point is the world is rampant with fraud and secure...
Now I will VENT. After weeks of research, and long online conversations, this morning my 2:1 multiplier is "In Stock" @ Quiktime...now the sleazy...
this was a batch made in NZ destined for the US 18 months ago.....where did they all go?
[IMG]
Yes, Ididit bought all the tooling and inventory, but I've been told (By them) that the ratio-reducer is NOT being produced currently and not in...
from the info I have it looks like the unit Quiktime sells is made by a guy in NZ. The plot thickens....
Separate names with a comma.
The Jalopy Journal
