The Jalopy Journal
[ATTACH] T&D machine shaft rockers for sbc Full set of 16. Handful of races on them. No shafts. Ready to run. 200 shipped
Good small block chevy Holley intake. Came off of running 350 engine. Changed manifolds due to drastic top end change. Asking 75 plus shipping...
Hi everyone, I was recently given a 327 that had been sitting in a barn for the past few years after it had been pulled. I believe it was...
I'm getting ready to pull the original 85hp flathead from my '39 Ford coupe along with the original 3 spd with it's worn out second gear synchro...
Ralph ridgeway ridge runner tunnel ram. Dual quad setup with two Holley 390cfm carbs list 8007. Carbs are fresh rebuilt. Holley bug catcher scoop....
$125 Nice old set of 9 fin aluminum valve covers, Cal Custom part #40-2050. One of the covers has had a crack welded at some point in its life....
Hello from Germany. --> About me [ATTACH] Can anyone tell me the differences between these 5 intakes? I want to use them on a 327 Chevy...
Chevy 350 long block, professionally rebuilt, mostly stock, cam is upgraded, I have the balancer and flywheel, the engine was balanced. I have...
Just removed a good running 1968 Chev 327ci engine with power pack (double hump) heads from my el Camino. Engine was running fine, but has around...
I have a nice early Man-a-fre intake withthe right Rochester 2g carbs,linkage,and fuel block. Intake has the small writing and says Atlanta. No...
Sold
Separate names with a comma.
The Jalopy Journal
Thread
