machine shop

Thread

Hi, I’m looking for a recommendation for a shop in the area to machine and possibly build the short lock of my 351 Cleveland. Not sure if...

Thread by: Kintanti, Feb 27, 2024, 0 replies, in forum: The Hokey Ass Message Board

Thread

Anyone living in the San Diego area know a machine shop with flathead Dodge experience, or one you would trust? Thanks.

Thread by: lostviking, Jan 7, 2024, 7 replies, in forum: The Hokey Ass Message Board

Thread

Hey, folks hope this message finds y'all well. I'm looking for a machine shop in N. Texas that would drill out new pressure plate mounting points...

Thread by: slowspoke, Apr 12, 2021, 3 replies, in forum: Traditional Hot Rods

Thread

Looking for a recommendation for a Central New York shop that can machine some 39 rear hubs to mate with by Buick finned Drums. I did a hub OVER...

Thread by: Boon BA, May 11, 2020, 3 replies, in forum: The Hokey Ass Message Board

Thread

hello to everyone. I been out of this all old stuff, for what seems like a lifetime ago I have been playing with mid sixties gassers. Anyway, I am...

Thread by: michael j bates, Feb 17, 2020, 0 replies, in forum: The Hokey Ass Message Board

Thread

Has anyone here had any luck locating a Flathead V8 shop in the DFW region this past year or two? I've left a few voicemails got shot down by one...

Thread by: slowspoke, Oct 20, 2019, 16 replies, in forum: Traditional Hot Rods

Thread

It's not Halloween, but I just had to share a no good, very bad engine shop experience... with Video! EDIT: while the vehicles aren't quite...

Thread by: turpentyne, Jan 24, 2019, 12 replies, in forum: The Hokey Ass Message Board