The Jalopy Journal
I have for sale the rear end and front axle from my 57 Chevy 3600 truck 3/4 ton. They are in rough condition, the truck was sitting for years...
All new Kiwi Quick Change from Derek Thomason, Nelson, New Zealand for Ford Model A rear end. It has never been installed. Centre is 3" 1/2" wide....
Hi everyone, I've got a 1/2 ton 52 chevy truck, and am trying to swap out the rear end with a later 66 chevy 10 bolt rear end. My 52 currently...
[ATTACH] picked this up when i bought a 29 model A, decided i wanted to use the 35 spoked rims, so the 5 wide hubs wouldn't work. never used it,...
[ATTACH] Ford 8" rear end from 1963 falcon. In good shape complete and also have shock mounts. $100
1965 Falcon 200 six, 1964 Falcon 2sp trans, driveline, rear end, torque converter, and Falcon gas tank. Contact for more info. Ryan
Complete open drive halibrand 201 quickchange. Case has been repaired well at some point. All new bearings, rear cover, 28 spline slip in axles...
Lincoln Hypoud Banjo Rear End with Lincoln hydrolic brakes and brake drums backing plates and torque tube. I obtained this when I purchased a 1932...
Hi all, i am new to the site and was hoping to get a little advise. I need to replace the original leaf springs on my 51. I have swapped out the...
Looking for some suggestions on rear suspension. 51 Plymouth Concord. Just installed rebuilt 360, have a 9" rearend installed on original leaf...
I have a few 1953-1954 Chevrolet Bel Air parts up for sale: Powerglide Transmission: $200 Powerglide Trans to 235 Adapter, flywheel, & starter:...
Sold thanks. 1934 ford rear end I pulled from my coupe. Complete other than the spring. Drums and backing plates have some pitting but the...
Ford 226ci "H"-code inline six engine, three-speed manual, and rear end from a 1950 Ford. Not sure of rear ratio or OD on transmission, will...
[ATTACH]
Need some help here guys i have a 33 tudor sedan on a 33 chassis if im running fenders how wide does the rear housing flange to flange on a...
Got a big ford 9'' in my hot rod, and can't get the right [passenger] side axle to seal up. Replaced the bearing, race, and stock seal twice....
i have a 51 buick straight 8 with 3 speed manual tranny. im trying to get it where i can run the car on the highway, ive read where the later...
Separate names with a comma.
The Jalopy Journal
Thread
