turn signals

Thread

I recently acquired a guide 6004 7 cloth wire turn signal. With the wires cut about 6” from the base. Set down on my kitchen table with a 12volt...

Thread by: highboy, Oct 6, 2025, 7 replies, in forum: Traditional Hot Rods

Thread

1940 Olds. Started engine, all gauges, (VDO) were working, including air conditioning. The gauges, and air went dead, along with turn signals. The...

Thread by: MWWADE, Jul 18, 2021, 17 replies, in forum: The Hokey Ass Message Board

Thread

I hadn't had any luck sourcing the turn signal buckets for my 54 210, save for some sketchy ebay chinese repops for $50 each so I decided to see...

Thread by: monteg0, Oct 31, 2019, 10 replies, in forum: The Hokey Ass Message Board

Thread

Hi everyone, I installed a flaming river steering column. I hooked up the wires to the steering column as reccomended. I checked each old wire...

Thread by: Eric Matwey, Jul 14, 2018, 8 replies, in forum: The Hokey Ass Message Board

Thread

I am wiring a 49 F1 with a new EZ Wire 12 circuit harness. It has an add on turn signal switch on the column. I need to figure out how to use this...

Thread by: Promotive, Aug 15, 2017, 8 replies, in forum: Traditional Hot Rods

Thread

I recently was nearly rear ended so I want to upgrade to LED 1157 type bulbs for the rear. I have a modern type signal stat unit and was wanting...

Thread by: Russco, May 1, 2017, 24 replies, in forum: The Hokey Ass Message Board