This is a 1927 Modet T Touring cut down vintage old school hot rod. I wish I had room for it because it is so cool but it's time to let go of this one. The body is a bit rough; I've replaced the rear seat panel and added some basic patch panels to the bottom but left the rest alone. It could make a great Rat Rod or Beater style build as it sits. It's channeled 6" up front and 3" in back (I'm told this was an East Coast thing back in the 50's & 60's). and sitting on a good, unmolested T frame with some tube crossmembers bolted in for mockup. The general breakdown: 27 T Modified on stock frame 50's GM swing pedals & Master Cylinder 30 Model A Radiator 36 Ford Front Axle with reverse eye spring. 49 Ford F1 front brakes & spindles 37 Ford front wishbone, split 47 Merc rear end & spring 40 Ford rear bones 40 ford rear brake drums & backing plates New smoothie 15" Wheel Vintique wheels 5" wide in the front & 6" out back New BF Goodrich Radial T/A's 155/80R15 in front and 235/70R15 in back, mounted and balanced. 1955 Chevrolet 265 SBC, turns and has compression (was an older rebuild that was stored, I haven't run it nor did I do the work) TH350, untested, so I have to assume it needs to be looked at or gone through. I also have other parts and options as far as engines and transmissions. I've got a couple 1955 cast Iron Powerglides, Later Aluminum body Powerglides, and 38-53 side-shift LaSalle transmissions as well as a Flathead Ford toploader (incomplete) available. I have a 59AB Ford Flathead project engine as well if that's the direction you'd rather take for a Traditional or TROG race car build. BILL OF SALE ONLY
The Jalopy Journal
