*Sale Pending* For Sale: 1932 Ford Tudor Sedan. Here are some details: -'32 Tudor body: Comes with dash, dash tunnel, windshield frame, rear window reg. panels, drivers door garnish. Has the orig. floor in good shape. It needs a patch in the drivers door bottom, the front bottom corner of the passenger door, the very bottom of the cowl on the passenger side, and there are pinholes at the very bottom of the rear panel. There are a couple of cracks at the very top of the rear panel above the rear window at the corners of the insert There are a couple of bullet holes. The quarter panels and the rest of the body is pretty solid. It will need a wood kit, and seat springs. The seat tracks are there. Cowl vent is there. -Original '32 firewall: Pretty nice piece, some light pitting on the engine side. -Original '32 frame: Nice early V8 frame (18-XXXX), uncut K-member, uncut rear crossmember, front crossmember is bolted in. -'32 pedal assembly -Dago dropped '33 axle -Unsplit '32 wishbone -'32 spring perches -'37-41 spindles: with steering arms bent to clear wishbone -'40 juice brakes: complete, will need wheel cylinders rebuilt. Nice orig. drums. -F100 steering: with new flange to fit stock frame -'40 Standard steering wheel -'41 Ford rearend: with shortened torque tube, driveshaft, and rear spring ground to fit stock rear crossmember. 3.78:1 ratio. -'46-48 rear wishbones -'40 rear brakes: will need wheel cylinders rebuilt. Complete with e-brake. -Running '49 Ford 8BA flathead: I bought this engine from Bob Wilson, and he had it on a run stand. It will need to be wired to the car. Complete from carb to pan to fan. Includes good clutch. Custom motor mounts -'39 Ford toploader trans: excellent condition. -Correct '32 transmission mount -Orig. '32 radiator: This was a 4-cyl. radiator that had the filler shaved and a neck added. Will need some work, but it's a decent original radiator. -Orig. '32 grille/insert: Shell has filled top, has some material on the back side trimmed. Driver quality insert, but both are original. -'40 16x4" wheels -6.00-16 and 7.50-16 bias ply tires. Fronts are older Allstate, rears are new. -Guide headlights It has a current clear Texas title that matches the original numbers stamped in the frame. This is a project car, but it has a lot of great original parts. The body would be relatively easy to get whipped into shape, and the car will just need brake lines, master cylinder, wiring, hoses, gas tank, fuel lines, and an interior to make it driveable. Price is $19,500 OBO. (Or Best Offer) Contact: E-mail: basskustoms@yahoo.com, Phone: 469-471-4929, or PM me.
The Jalopy Journal
