Hot Rods 1933 ford C-4

I now have a 33 ford with a C-4-- open drive-- 1950 flathead eng.
I am in the process of a new to me frame( 1933 ) 21 stud eng C-4 with closed drive.
I am thinking about the short tail shaft with the bolt on U-joint.
This would mate to the ford closed drive shaft.
anyone out there done this ? any ideas ?
Thanks for any help
Nick 510-889-1933

 

You planning on building a "female" knuckle for the torque tube to mate to or a mix of open to closed drive?...if yor planning on some sort of "adapter " it will need to pivot in the center of the u joint.....perhaps a sleeve to slide into the torque tube with heims onon either side of the u joint fastened to the tail housing or crossmember?.....a similar setup was used in dirt modifieds in the late 80s


Posted using the Full Custom H.A.M.B. App!