Register now to get rid of these ads!

Technical 1957 Olds Rocket engine questions

Discussion in 'The Hokey Ass Message Board' started by domingo, Mar 24, 2014.

  1. domingo
    Joined: Sep 22, 2012
    Posts: 78

    domingo
    Member
    from Lima, Peru

    Hi!

    I have a 1957 Oldsmobile 98 4 door in Lima, PERU.

    Bad thing is that its missing the main parts of its original engine: shortblock and heads..... however the transmission is there as well as the lower trans shield, valve convers, intake and 4 barrel carb, rocker arms and shafts, starter, alternator, damper, etc.....

    I have a lead on another Olds Engine, however I doubt it is a 57 engine.

    I was wondering which year Oldsmobile engines would look basically the same on the outside appereances as a 57 Rocket and would mate to my tranmission just fine so I could install it on my 57 and not look like I built a Frankenstein????

    Id like to have an engine inside the engine compartment, that even though it is not a 371 it still would look like one, or at least super close (unless its an oldsmobile expert looking at it).

    Thanks!

    D
     
  2. junkyardjeff
    Joined: Jul 23, 2005
    Posts: 8,690

    junkyardjeff
    Member

    A 58 motor would be identical and you could use a 59 to 64 motor but they are a little wider.
     
  3. email Goatroper2. Tony has anything you need.
     
  4. domingo
    Joined: Sep 22, 2012
    Posts: 78

    domingo
    Member
    from Lima, Peru

    Wider because the deck on the block is taller, otherwise aesthetically very similar? (Heads, exhaust, accerrsories, timing chain, etc the same) but a little taller block and a wider intake?

    Like saying....383 vs. a 440 on a mopar application?

    Thanks.

    D
     
  5. Yes, because of taller deck height on the later engines. 59-64 are the tallest and therefore only slightly wider than your 57-58. I believe all 49-56 are the same lowest deck height. They all are basically similar external appearance, not sure if there are differences in the engine mounts?

    X2 pm or email goatroper Tony, he is early Olds expert.
     
  6. Johnny Gee
    Joined: Dec 3, 2009
    Posts: 14,087

    Johnny Gee
    Member
    from Downey, Ca

  7. dan griffin
    Joined: Dec 25, 2009
    Posts: 505

    dan griffin
    Member

    A 56 jetaway eng. will fit your trans.Rocker arms and shafts will work 49-58.
     

Share This Page

Register now to get rid of these ads!

Archive

Copyright © 1995-2021 The Jalopy Journal: Steal our stuff, we'll kick your teeth in. Terms of Service. Privacy Policy.

Atomic Industry
Forum software by XenForo™ ©2010-2014 XenForo Ltd.