I really need some help. I just converted my 235 from 6v to 12v and it is not firing. I replace the generator with a 12 alternator. I kept the starter the same. I have a 12v coil and I replaced the distributer, cap and rotor. The negative side of the coil is going to the distributer and positive to the alternator. I have the engine turn over pretty strongly but it does not fire. I have checked for spark from the number one cylinder spark plug test and I am not getting spark. My coil is reading good. Last time I tried to get it to crank I saw sparks coming from my starter so I stopped for now. Please if anyone can help I would sure appreciate the help.
run a jumper wire from the positive terminal of the coil to the positive terminal on the battery. check that the points are working with a test light, at the coil negative terminal while cranking the engine. if the light strobes the points are working. next check the secondary wire from the coil to the disributor cap.
Shiro, Please read the Sticky when you can, and make a proper Intro about yourself and become a member of the H.A.M.B. family. It's a good place to be, informative and entertaining, and very addictive in a good way. Good Luck with your electrical problem. Welcome to the H.A.M.B. firstnomad www.angelfire.com/jazz/flatlandstudio
I have a continuity tester. How can I use this in this whole process. It is the only test light I could find. It is basically a pen looking deal that glows attached to an aligator clip.
The Jalopy Journal
