Technical 32/34 rear axle dimensions

Do both the car and truck have the same hub to hub and driveshaft lengths??
Anyone happen to have those dimensions?
Are they 6 spline?
Thx. PJ

 

Found the width and spline info. But not the driveshaft length yet.

https://www.hotrodworks.com/technical-information/rear-axle-measurements/

 

Found the torque tube and shaft lengths.

https://www.fordbarn.com/forum/showthread.php?t=186283&highlight=1932+drive+shaft+length

 

Yes, all vehicles based on the passenger car frame used the same axle assemblies for 1932 and then 1933/34. The large trucks used rear axles of an entirely different design.

 

Driveshaft is 10 spline and the cross pin hole in 10 spline pinion is 3/8 th of an inch further back than a 6 spline pinion