Register now to get rid of these ads!

Customs '54 Buick build

Discussion in 'The Hokey Ass Message Board' started by DeathProofMike, Feb 5, 2017.

  1. DeathProofMike
    Joined: Jan 9, 2017
    Posts: 5

    DeathProofMike
    Member
    from 08865

    I picked up a '54 Buick Special for my girlfriend. The original 264 nailhead was shot and is long since gone. The project came with a Buick 455, but we also have a Chevy 350 sitting in the club garage that I can use. I prefer to use the 350 for a few reasons. I have the same exact block in my Nova, so I already have some extra parts to build it. This car is going to go to some shows that are a good distance away, so I would like to be able to walk into any parts store and get parts if there is a failure. That being said, I plan to sell the 455 and use the 350. My question is does anyone make a bolt on/weld in kit to drop a SBC in the Buick? I started digging around a little and haven't found much so far.
     

Share This Page

Register now to get rid of these ads!

Archive

Copyright © 1995-2021 The Jalopy Journal: Steal our stuff, we'll kick your teeth in. Terms of Service. Privacy Policy.

Atomic Industry
Forum software by XenForo™ ©2010-2014 XenForo Ltd.