Technical anyone have measurememnts for front and rear rivet holes for crossmembers on a 32 frame

hello
using a metal flexible rule.
measuring from the flat at the front and along the outside of the rail, coming in at 90 degrees to the central hole

what are the measurements front and rear?
thanks

also IF you have bought aftermarket front and rear spreader bars
is there a spaceer thing that sits inside the m - like a stiffener that adds some?
thanks

 

I don't have what you need but couldn't any of the better '32 frame fabricators help you out?

 

@nobby
Yes on spreader needs a spacer on inside
Can not remember 3/16 or 1/4 thick ,
Both sides between spreader & frame
Front & rear
Pic below is FoMoCo blueprint .

 

My chassis is built from ASC rails, they didn't send the spacers, my friend built the chassis and set the rear rail width with spacer thickness at 39&3/4" spacer to spacer and ordered the spacers later, the deuce factory spreader bar is 39&1/2" wide, the bolts draw in the difference.


Your results may vary.