Register now to get rid of these ads!

Technical Barn find 57 vette.

Discussion in 'The Hokey Ass Message Board' started by racer-x, Jul 24, 2021.

  1. Jay Leno just featured a very nice survivor GTO with a bunch of rare options.

     
    41 GMC K-18 and racer-x like this.
  2. tomcat11
    Joined: Mar 31, 2010
    Posts: 990

    tomcat11
    Member

    Just now finished reading this whole thread. Very entertaining story to say the least. Learned a bunch as well. The Corvette is very cool. Nice work on that. You've got a super cool Corvette, some hearty farmer friends, some yard art, and a 421 Pontiac Tri-Power for your efforts. Finding the severed hand in the jar is probably a bit too much for a typical barn find. :eek:
     
    WC145, guthriesmith and 41 GMC K-18 like this.
  3. I have to ask suzzie if she found her hand while clearing the place out. She told me it was in a jar. She described it as looking like a dolls hand. You just can't make this stuff up. Her arm was severed at the shoulder.
     
  4. The gto I rode in everyday was a lighter gold than that. Almost the color of sand.
     
    loudbang and 41 GMC K-18 like this.
  5. Back on the vette. Adjusting brakes today. They are not auto adjusting. The pedal was down some. It's all good for the driving season now. I greased everything while it was up in the air. 20240608_144853.jpg
     
  6. Man, I love this car! I’m still holding my breath for a similar find. :D
     
    41 GMC K-18, Cosmo49 and 427 sleeper like this.
  7. Dennis D
    Joined: May 2, 2009
    Posts: 857

    Dennis D
    Member

    I lost my wife too, only not in a flood, her name wasn't ID. Sorry.......
     
  8. I ran into suzzie. I asked about the hand. She did not find it. She thinks her sister has it. Jim and suzzie will both be at the Out of Site drags next weekend. The vette will be there to
     
  9. That’s hilarious!
     
  10. big john d
    Joined: Nov 24, 2011
    Posts: 407

    big john d
    Member
    from ma

    a quick hack that works quite well for stripped sheet metal screws is take about an inch and a half piece of a zip tie bend it into a v and bend two short wings push it into the hole the wings keep it from falling in it is surprising how tightyou can put a screw in it
     
    racer-x, LowKat and impala4speed like this.
  11. I've used short piece of solid copper wire for same effect too.
     
    racer-x likes this.
  12. Fortunateson
    Joined: Apr 30, 2012
    Posts: 5,515

    Fortunateson
    Member


    What was the mallet for? Persuasion?
     
    Jiminy likes this.

Share This Page

Register now to get rid of these ads!

Archive

Copyright © 1995-2021 The Jalopy Journal: Steal our stuff, we'll kick your teeth in. Terms of Service. Privacy Policy.

Atomic Industry
Forum software by XenForo™ ©2010-2014 XenForo Ltd.